Biomechanical Assessment of the NIOSH Lifting Equation in Asymmetric Load-Handling Activities Using a Detailed Musculoskeletal Model
Authors:
- 17 September 2018
- journal article
- research article
- Published by SAGE Publications in Human Factors: The Journal of the Human Factors and Ergonomics Society
- Vol. 61 (2) , 191-202
Abstract
Objective: To assess adequacy of the National Institute for Occupational Safety and Health (NIOSH) Lifting Equation (NLE) in controlling lumbar spine loads below their recommended action limits during asymmetric load-handling activities using a detailed musculoskeletal model, that is, the AnyBody Modeling System. Background: The NIOSH committee employed simplistic biomechanical models for the calculation of the spine compressive loads with no estimates of the shear loads. It is therefore unknown whether the NLE would adequately control lumbar compression and shear loads below their recommended action limits during asymmetric load-handling activities. Method: Twenty-four static stoop lifting tasks at different load asymmetry angles, heights, and horizontal distances were performed by one normal-weight (70 kg) and one obese (93 kg) individual. For each task, the recommended weight limit computed by the NLE and body segment angles measured by a video-camera system (VICON) were prescribed in the participant-specific models developed in the AnyBody Modeling System that estimated spinal loads. Results: For both individuals, the NLE adequately controlled L5-S1 loads below their recommended action limits for all activities performed in upright postures. Both individuals, however, experienced compressive and/or shear L5-S1 loads beyond the recommended action limits when lifting was performed near the floor with large load asymmetry. Conclusion: The NLE failed to control spinal loads below the recommended limits during asymmetric lifting tasks performed near the floor. Application: The NLE should be used with caution for extreme tasks involving load handling near the floor with large load asymmetry.Keywords
Funding Information
- Sharif University of Technology
This publication has 30 references indexed in Scilit:
- Revised NIOSH Lifting Equation May generate spine loads exceeding recommended limitsInternational Journal of Industrial Ergonomics, 2015
- Comparative evaluation of six quantitative lifting tools to estimate spine loads during static activitiesApplied Ergonomics, 2015
- Tolerance of the lumbar spine to shear: A review and recommended exposure limitsClinical Biomechanics, 2012
- Predictive equations for lumbar spine loads in load-dependent asymmetric one- and two-handed lifting activitiesClinical Biomechanics, 2012
- A comparative study of two trunk biomechanical models under symmetric and asymmetric loadingsJournal of Biomechanics, 2010
- Comparison of trunk muscle forces and spinal loads estimated by two biomechanical modelsClinical Biomechanics, 2009
- A generic detailed rigid-body lumbar spine modelJournal of Biomechanics, 2007
- Analysis of squat and stoop dynamic liftings: muscle forces and internal spinal loadsEuropean Spine Journal, 2006
- Wrapping of trunk thoracic extensor muscles influences muscle forces and spinal loads in lifting tasksClinical Biomechanics, 2006
- Model and in vivo studies on human trunk load partitioning and stability in isometric forward flexionsJournal of Biomechanics, 2006