Microlayer in nucleate boiling seen as Landau–Levich film with dewetting and evaporation
Authors:
- Cassiano TecchioCTCassiano Tecchio
- XiaolongZhang(张晓龙)XIXiaolongZhang(张晓龙)
- Vadim S. NikolayevVNVadim S. Nikolayev
Open Access
- 25 June 2024
- journal article
- research article
- Published by Cambridge University Press (CUP) in Journal of Fluid Mechanics
- Vol. 989, A4
Abstract
Both experimental and theoretical studies of fast and microscale physical phenomena occurring during the growth of vapour bubbles in nucleate pool boiling are reported. The focus is on the liquid film of micrometric thickness (a ‘microlayer’) that can form between the heater and the liquid–vapour interface of a bubble. The microlayer strongly affects the macroscale heat transfer and is thus important to be understood. The microlayer appears as a result of the inertial forces that cause the hemispherical bubble shape. It is shown that the microlayer can be seen as the Landau–Levich film deposited by the bubble foot edge during its receding. Paradoxically, the deposition is controlled by viscosity and surface tension. The microlayer profile measured with white-light interferometry, the temperature distribution over the heater, and the bubble shape are observed with synchronised high-speed cameras. According to the numerical simulations, the microlayer consists of two regions: a dewetting ridge near the contact line, and a longer and flatter bumped part. It is shown that the ridge cannot be measured by interferometry because of its intrinsic limitation on the interface slope. The ridge growth is linked to the contact line receding. The simulated dynamics of both the bumped part and the contact line agrees with the experiment. The physical origin of the bump in the flatter part of microlayer is explained.Keywords
All Related Versions
This publication has 42 references indexed in Scilit:
- Evaporation Effect on the Contact Angle and Contact Line Dynamics2021
- The hydrodynamics of microlayer formation beneath vapour bubblesInternational Journal of Heat and Mass Transfer, 2016
- Pressure drop and void fraction during flow boiling in rectangular minichannels in weightlessnessApplied Thermal Engineering, 2013
- An investigation of microlayer beneath nucleation bubble by laser interferometric methodInternational Journal of Heat and Mass Transfer, 2013
- An approximate analytical solution of the hydrodynamic problem associated with an advancing liquid-gas contact lineInternational Journal of Multiphase Flow, 1991
- Formation and stability of a liquid microlayer in pool boiling and growth of a dry areaChemical Engineering Science, 1978
- Calculation of the ?initial? thickness of the ?microlayer? during bubble boilingJournal of Engineering Physics and Thermophysics, 1975
- Principal mechanism of micro-liquid-layer formation on a solid surface with a growing bubble in nucleate boilingInternational Journal of Heat and Mass Transfer, 1970
- The microlayer in nucleate pool boilingInternational Journal of Heat and Mass Transfer, 1969
- Simultaneous determination of microlayer geometry and bubble growth in nucleate boilingInternational Journal of Heat and Mass Transfer, 1969