Fabrication and Characterization of Superconducting Probe Coil for High-Sensitivity NMR Spectroscopy
Authors:
- Hiroyuki YamamotoHYHiroyuki Yamamoto
- Masaya TakahashiMTMasaya Takahashi
- Kazuo SaitohKSKazuo Saitoh
- Kenji KawasakiKKKenji Kawasaki
- Yuzo FukudaYFYuzo Fukuda
- Hiroyuki TanakaHTHiroyuki Tanaka
- Michiya OkadaMOMichiya Okada
- Hitoshi KitaguchiHKHitoshi Kitaguchi
- 5 June 2009
- journal article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Applied Superconductivity
- Vol. 19 (3) , 386-388
Abstract
A solenoidal-shaped superconducting probe coil for taking NMR measurements was fabricated using Bi2Sr2CaCu2Ox (Bi-2212), and then its quality factor was evaluated. The Bi-2212 probe coil was fabricated by dip-coating process. The quality factor values were Q = 5960-8820 (4.2 K, 0 T) in a frequency range of 400-600 MHz. These values were 2.3-2.5 times higher than those for a normal metal probe coil under the same measurement set up. In addition, the Bi-2212 probe coil maintained its superiority over a normal metal one even in a magnetic field up to 7 T. The measurement sensitivity of NMR depends on the quality factor of the probe coil. Therefore, the present experimental results obtained using the superconducting Bi-2212 probe coil are promising for taking high-sensitivity NMR measurements.Keywords
This publication has 16 references indexed in Scilit:
- Development of cryogenic probe system for high-sensitive NMR spectroscopyJournal of Physics: Conference Series, 2008
- Fabrication and characterization of High-Q NMR antenna coil using superconducting MgB2thin filmsJournal of Physics: Conference Series, 2008
- Relationship Between Surface Resistance and Critical Current Density of HTS Thin Films in a DC Magnetic FieldIEEE Transactions on Applied Superconductivity, 2005
- Dependence of Surface Resistance in HTS Thin Films on a DC Magnetic FieldIEEE Transactions on Applied Superconductivity, 2005
- Surface YBa/sub 2/Cu/sub 3/O/sub 7/ receive coils for low field MRIIEEE Transactions on Applied Superconductivity, 2001
- Optimization of melt-processing temperature and period to improve critical current density of Bi2Sr2CaCu2Ox/Ag multilayer tapesPhysica C: Superconductivity and its Applications, 1999
- Influence of Ag substrates on grain alignment and critical current density of Bi-2212 tape conductorsIEEE Transactions on Applied Superconductivity, 1999
- A superconducting probehead applicable for nuclear magnetic resonance microscopy at 7 TReview of Scientific Instruments, 1998
- Frequency dependence of the surface impedance of thin films in a dc magnetic field: Investigation of vortex dynamicsPhysical Review B, 1994
- Preparation of the textured Bi-based oxide tapes by partial melting processIEEE Transactions on Magnetics, 1991