Casting Pore Characterization by X-Ray Computed Tomography and Metallography
Open Access
- 1 January 2010
- journal article
- research article
- Published by Polish Academy of Sciences Chancellery in Archive of Mechanical Engineering
- Vol. 57 (3) , 263-273
Abstract
Casting Pore Characterization by X-Ray Computed Tomography and Metallography: Casting porosity is the main factor influencing the fatigue properties of Al-Si alloys. Due to the increasing use of aluminum castings, porosity characterization is useful for estimating their fatigue strength. In principle, a combination of metallographic techniques and statistical pore analysis is a suitable approach for predicting the largest defect size that is critical for the casting. Here, the influence of modifiers and casting technology on the largest pore size population in AlSi7Mg alloy specimens is obtained and discussed adopting the Murakami's approach. However, porosity evaluation is a challenge in the case of microshrinkage pores, which are frequently found in industrial castings. Their complicated morphology prevents a reliable definition of an equivalent defect size based on metallographic techniques. This contribution reports the application of X-ray tomography to the 3D reconstruction of real pores in cast Al-Si alloys and provides insight into the complication of microshrinkage pore sizing by metallography.Keywords
This publication has 3 references indexed in Scilit:
- Prediction of Fatigue Performance in Aluminum Shape Castings Containing DefectsMetallurgical and Materials Transactions B, 2007
- Fatigue behavior of A356-T6 aluminum cast alloys. Part I. Effect of casting defectsJournal of Light Metals, 2001
- The Quantitative Discrimination between Shrinkage and Gas Microporosity in Cast Aluminum Alloys Using Spatial Data AnalysisMaterials Characterization, 1999