Influence of cutting speed and particulate content on polycrystalline diamond tool wear in machining AA7075/TiB2 in situ aluminum matrix composites
- 8 May 2024
- journal article
- research article
- Published by Elsevier in Measurement
- Vol. 234
Abstract
No abstract availableKeywords
This publication has 37 references indexed in Scilit:
- A critical review on tool wear mechanism and surface integrity aspects of SiCp/Al MMCs during turning: prospects and challengesThe International Journal of Advanced Manufacturing Technology, 2023
- Cutting force model and damage formation mechanism in milling of 70wt% Si/Al compositeChinese Journal of Aeronautics, 2022
- Improving the mechanical properties of carbon nanotubes reinforced aluminum matrix composites by heterogeneous structural designComposites Communications, 2022
- Investigation of the tool wear, surface roughness, and chip formation in the machining of ZrO2-reinforced aluminum compositesJournal of the Brazilian Society of Mechanical Sciences and Engineering, 2020
- A review on conventional and nonconventional machining of SiC particle-reinforced aluminium matrix compositesAdvances in Manufacturing, 2020
- An experimental study on single-point diamond turning of a 55 vol% SiCp/Al composite below the ductile brittle transition depth of SiCThe International Journal of Advanced Manufacturing Technology, 2020
- Effects of cooling and lubrication conditions on tool wear in turning of Al/SiCp compositeThe International Journal of Advanced Manufacturing Technology, 2019
- A review on machining and optimization of particle-reinforced metal matrix compositesThe International Journal of Advanced Manufacturing Technology, 2018
- Prediction model of tool wear volume in precision turning of ceramic particle reinforced aluminum matrix compositesThe International Journal of Advanced Manufacturing Technology, 2018
- Investigations of flank wear, cutting force, and surface roughness in the machining of Al-6061–TiB2 in situ metal matrix composites produced by flux-assisted synthesisThe International Journal of Advanced Manufacturing Technology, 2010