Water Flow in, Through, and Around the Gas Diffusion Layer
Authors:
- 11 September 2012
- journal article
- research article
- Published by Wiley in Fuel Cells
- Vol. 12 (5) , 835-847
Abstract
Liquid water produced in polymer electrolyte membrane fuel cells is transported from the cathode catalyst/membrane interface through the gas diffusion layer (GDL) to the gas flow channel. Liquid water travels both laterally (in the plane of GDL) and transversely through the largest pores of the porous GDL structure. Narrow apertures in the largest pores are the primary resistance to liquid water penetration. Carbon paper has limiting apertures ∼20 μm in diameter and ∼1 μm in length whereas carbon cloth has apertures ∼100 μm in diameter and ∼200 μm in length. After sufficient hydrostatic pressure is applied, water penetrates the limiting aperture and flows through the pore. The pressure required for water to flow through the pores is less than the pressure to penetrate the limiting aperture of the pores. Water moved laterally and directed through a small number of transverse pores. There is less resistance to lateral liquid water flow at the interface between the GDL and a solid surface than through the GDL. The results from these experiments suggest that water flow through the GDL is dominated by a small number of pores and most pores remain free of liquid water.Keywords
This publication has 48 references indexed in Scilit:
- Effect of a GDL based on carbon paper or carbon cloth on PEM fuel cell performanceFuel, 2011
- Controllability and Observability Analysis of the Liquid Water Distribution Inside the Gas Diffusion Layer of a Unit Fuel Cell ModelJournal of Dynamic Systems, Measurement, and Control, 2010
- Effect of Hydrophobicity in Cathode Porous Media on PEM Fuel Cell PerformanceJournal of Fuel Cell Science and Technology, 2010
- Effects of GDL Structure with an Efficient Approach to the Management of Liquid water in PEM Fuel CellsFuel Cells, 2010
- Effect of cathode GDL characteristics on mass transport in PEM fuel cellsFuel, 2009
- Microporous layer for water morphology control in PEMFCInternational Journal of Heat and Mass Transfer, 2009
- Effect of hydrophobicity and pore geometry in cathode GDL on PEM fuel cell performanceElectrochimica Acta, 2009
- Characterization of internal wetting in polymer electrolyte membrane gas diffusion layersJournal of Power Sources, 2009
- A microfluidic approach for measuring capillary pressure in PEMFC gas diffusion layersElectrochemistry Communications, 2007
- Characterization of transport properties in gas diffusion layers for proton exchange membrane fuel cellsJournal of Power Sources, 2006