Mechanisms Behind Low Salinity Water Flooding in Carbonate Reservoirs
Authors:
- 19 April 2013
- conference paper
- Published by Society of Petroleum Engineers (SPE)
Abstract
The low salinity water injection method (LoSal) has become one of the important research topics in the oil industry because of its enormous possible advantages. The objective of this paper is to investigate the mechanism behind the LoSal effect on oil recovery through data matching. The UTCHEM simulator was used to match the cycles of the injected seawater and different dilutions of the latter for two recently published coreflooding experiments. The result from the history matching revealed that the wettability alteration mechanism is believed to be the main contributor to LoSal. Based on this finding, an analytical model for oil recovery predictions can be developed. Introduction Carbonate rocks account for more than half the world's hydrocarbon proven reserves. Oil recovery from these reservoirs is a challenge due to their complex nature. The problem becomes even more complicated when wettability ranges from mixed-wet to oil-wet rocks with a low permeability matrix and high fracture density as in most carbonate reservoirs. Consequently, several enhanced oil recovery techniques have been proposed to improve oil recovery of these reservoirs and overcome the high negative capillary pressure that holds oil in place. One of the suggested techniques is altering the wettability of these reservoirs from oil-wet towards more water-wet, which turns the capillary pressure positive and begins spontaneous water imbibition into the low permeability rock matrix resulting in higher oil recovery. One of the emerging enhanced oil recovery (EOR) techniques for wettability alteration in carbonate reservoirs is low salinity water injection. The popularity of this technique is due to its efficiency in displacing light to medium gravity crude oils, ease of injection into oil-bearing formations, water availability and affordability, and lower capital and operating costs, all of which lead to favorable economics compared to other chemical and thermal EOR methods. The only concern with this technique is water sourcing and water disposal. This low salinity water injection EOR technique is also known in the literature as LoSal, Smart Waterflood, and Advanced Ion Management. Several studies have been done on LoSal water injection at laboratory scale and to a limited extent at field-scale. A review of the effect of LoSal water injection on both sandstone and carbonate rocks is presented below. Extensive laboratory studies were conducted on sandstone rocks after producing 15% additional oil from the Kansas field when brine was used as injection fluid compared to fresh water (Smith, 1942). The relative effectiveness of fresh and salt water on oil recovery from synthetic and natural cores containing clays was investigated by Bernard (1967). An increase in oil recovery from Berea sandstone cores by increasing the salinity up to a certain level after which recovery did not increase significantly was reported by Al-Mumen (1990). Both connate and invading brines have major effects on wettability and oil recovery at reservoir temperature as was reported by both Tang and Morrow (1997). Several coreflood experiments investigated the effect of low salinity brine on improving oil recovery from Berea sandstone cores for both secondary and tertiary injection modes (Zhang et al., 2007). The incremental oil recovery from sandstone rocks was in the range of 5-20% of OOIP as reported by several studies (Lager et al., 2007; Lager et al., 2008; Webb et al., 2005a; Webb et al., 2008).Keywords
This publication has 17 references indexed in Scilit:
- Enhanced Waterflood for Middle East Carbonate Cores — Impact of Injection Water Composition2011
- Laboratory Investigation of Novel Oil Recovery Method for Carbonate Reservoirs2010
- LoSal™ Enhanced Oil Recovery: Evidence of Enhanced Oil Recovery at the Reservoir Scale2008
- Improving Wateflood Recovery: LoSal™ EOR Field Evaluation2008
- Wettability alteration and improved oil recovery by spontaneous imbibition of seawater into chalk: Impact of the potential determining ions Ca2+, Mg2+, and SO42−Colloids and Surfaces A: Physicochemical and Engineering Aspects, 2007
- Understanding Waterflood Residual Oil Saturation of Four Carbonate Rock Types2001
- Salinity, Temperature, Oil Composition, and Oil Recovery by WaterfloodingSPE Reservoir Engineering, 1997
- The Influence of Fluid Viscosity, Interfacial Tension, and Flow Velocity on Residual Oil Saturation Left by WaterfloodSociety of Petroleum Engineers Journal, 1975
- Effect of Floodwater Salinity on Recovery Of Oil from Cores Containing Clays1967
- Three-Phase Relative PermeabilityJournal of Petroleum Technology, 1956