Abstract
Experimental study on model micropiles was undertaken in field conditions to ascertain pullout capacity of vertical micropile under oblique loads. Micropiles of 25-mm diameter and embedded lengths of 300 mm, 400 mm and 600 mm (L/D-12, -16 and -24) were auger-drilled and casted in silty sand (SM soil). Reinforcement in the form of 10-mm Tor steel bar was provided at the center of each borehole. Thoroughly mixed neat cement water grout of 0.45 w/c ratio was poured into boreholes under gravity through a pipe. Ample cured micropiles were tested under incremental pullout loads applied at 0-, 5-, 10-, 15-, 20-, 30-, 45- and 90-degree inclinations with respect to axis of micropiles i.e. vertical. For each load inclination, ultimate pullout capacity was determined from load-deformation curves and was also calculated theoretically. Test results indicate that ultimate pullout capacity increases with increase in L/D ratio and decreases as load inclination increases with micropile axis. Load inclination, at which mode of failure changes from axial to lateral (i.e. critical angle), was found between 5-10 degrees with axis of micropile. Lateral pullout capacity is obtained at 25-30% of the axial pullout capacity.

This publication has 7 references indexed in Scilit: