Density improvement of alumina parts produced through selective laser sintering of alumina-polyamide composite powder
Authors:
- Jan DeckersJDJan Deckers
- Jean-Pierre KruthJKJean-Pierre Kruth
- Khuram ShahzadKSKhuram Shahzad
- Jef VleugelsJVJef Vleugels
- 1 January 2012
- journal article
- Published by Elsevier in CIRP Annals
- Vol. 61 (1) , 211-214
Abstract
No abstract availableKeywords
This publication has 9 references indexed in Scilit:
- Preparation and indirect selective laser sintering of alumina/PA microspheresCeramics International, 2012
- The investigation of the influence of laser re‐melting on density, surface quality and microstructure of selective laser melting partsRapid Prototyping Journal, 2011
- Manufacturing by combining Selective Laser Melting and Selective Laser Erosion/laser re-meltingCIRP Annals, 2011
- Consolidation phenomena in laser and powder-bed based layered manufacturingCIRP Annals, 2007
- Al2O3–SiC composites prepared by warm pressing and sintering of an organosilicon polymer-coated alumina powderJournal of the European Ceramic Society, 2007
- Rapid manufacturing of silicon carbide compositesRapid Prototyping Journal, 2005
- Experimental investigation into the selective laser sintering of silicon carbide polyamide compositesProceedings of the Institution of Mechanical Engineers, Part B: Journal of Engineering Manufacture, 2004
- Processing of titanium net shapes by SLS/HIPMaterials & Design (1980-2015), 1999
- Selective laser sintering of alumina with polymer bindersRapid Prototyping Journal, 1995