Fire performance and spalling mitigation in high-strength and eps-modified mortars under transient thermal exposure
Authors:
Open Access
- 12 September 2025
- journal article
- research article
- Published by Springer Nature in Scientific Reports
- Vol. 15 (1) , 1-24
Abstract
High-strength cementitious composites are highly susceptible to explosive spalling at elevated temperatures, necessitating innovative fire resilience strategies. This study investigates the dual role of expanded polystyrene (EPS) beads as both lightweight aggregate and spalling mitigator in mortars subjected to short-term, rapid thermal exposure. High-strength mortar (HSM) and EPS-modified mortar were exposed to temperatures up to 600 °C with brief dwell times (10–30 min), followed by furnace or water cooling. Residual properties and microstructural evolution were systematically evaluated. Results revealed a fundamental temperature-dependent shift in EPS performance. At 400 °C, EPS incorporation prevented explosive spalling across all cooling regimes by generating porosity that dissipated internal vapor pressure, while plain HSM suffered severe spalling. Both mixtures showed strength gains at 200 °C due to thermal activation, though EPS mortar exhibited attenuated improvements. At 400 °C, EPS mortar experienced progressive strength loss attributed to bead decomposition and resulting porosity increases. EPS-enhanced thermal insulation was confirmed through significantly reduced core temperatures. However, under extreme conditions (600 °C), EPS decomposition triggered catastrophic spalling. Microstructural analysis showed EPS-induced voids transitioned from beneficial pores to critical defects with increasing temperature, while elemental analysis confirmed degradation was primarily physical rather than chemical. These findings demonstrate EPS’s viability for spalling mitigation in moderate fire scenarios, though its application requires careful temperature management. The study underscores the importance of evaluating fire mitigation materials under realistic transient heating conditions.Keywords
Funding Information
- National Research Centre Egypt
This publication has 59 references indexed in Scilit:
- Effect of micro‐structural changes on concrete properties at elevated temperature: Current knowledge and outlookStructural Concrete, 2021
- Lightweight structural cement composites with expanded polystyrene (EPS) for enhanced thermal insulationCement and Concrete Composites, 2019
- Effect of cooling on the residual mechanical properties and cracking of plain and fibrous geopolymer concretes at elevated temperaturesStructural Concrete, 2019
- Dynamic Mechanical Properties of EPS Concrete Under Impact LoadingJournal of Shanghai Jiaotong University (Science), 2019
- Mechanism of PVA fibers in mitigating explosive spalling of engineered cementitious composite at elevated temperatureCement and Concrete Composites, 2018
- Effect of cooling methods on residual compressive strength and cracking behavior of fly ash concretes exposed at elevated temperaturesFire and Materials, 2014
- Physical and mechanical properties of heat‐damaged structural concrete containing expanded polystyrene syntherized particlesFire and Materials, 2014
- Experimental and numerical studies of thermo-hydrous transfers in concrete exposed to high temperatureHeat and Mass Transfer, 2007
- High strength blended cement concrete incorporating volcanic ash: Performance at high temperaturesCement and Concrete Composites, 2006
- Effects of elevated temperature exposure on heating characteristics, spalling, and residual properties of high performance concreteMaterials and Structures, 2001