Residual Stress Development and Deformation of Wire-Arc Direct Energy Deposition Parts

Authors:

Abstract
Wire-arc direct energy deposition (Wire-arc DED) enables efficient fabrication of large metallic components because of its high deposition rate and high material efficiency. However conventional Wirearc DED relies on a build plate to constrain part deformation during deposition, which requires postprocessing removal and can increase material waste and residual strain redistribution. This project investigated the feasibility of shifting Wire-arc DED toward build plate free, freeform fabrication by examining residual strain and distortion development in three walls: (1) as-deposited, (b) base plate removal, and (3) freeform wall printed without a base plate using a small anchor support. Residual strains were measured using neutron diffraction method at ORNL’s High Flux Isotope Reactor (HFIR). A sequentially coupled thermo-mechanical finite element framework was developed to simulate deposition, cooling, boundary condition changes associated with base plate removal and freeform deposition. The model captured characteristic strain bands, edge tension, mid-height compression, and strain re-distribution after base plate removal. Statistical comparisons using standard deviation, RMSE, normalized RMSE, and bias showed better quantitative agreement for the base-plate and base plate removal cases than for the freeform wall although the freeform simulation still reasonably captured the overall strain magnitude and trend. Overall, the predicted and measured results demonstrate the capability of a physics-based, 5-axis tool path aware modeling framework for residual strain prediction in Wire-arc DED. Also, the work identified key modeling gaps including free surface deformation, bottom layer sagging, material hardening behavior, 5-axis associated heat distribution, and geometric uncertainty and discussed for improved residual strain prediction.
Funding Information
  • USDOE Office of Critical Minerals and Energy Innovation (CMEI), Office of Critical Minerals, Materials, and Manufacturing (CM3). Advanced Materials and Manufacturing Technologies Office (AMMTO) (AC05-00OR22725)