Influence of Concentration and pH of Hexafluorozirconic Acid on Corrosion Resistance of Anodized AA7075-T6
Open Access
- 1 January 2019
- journal article
- research article
- Published by FapUNIFESP (SciELO) in Materials Research
- Vol. 22 (suppl 1)
Abstract
7XXX aluminum alloys show high mechanical resistance and low weight, both required properties for aircraft industry. Anodizing is an electrolytical process typically used to improve the corrosion resistance of aluminum alloys, through which a thicker and porous oxide is formed. Boiling water is used as a common sealing method to the anodic layer; however, it implies energy expenditure. In this work, a two-step coating system was performed: anodizing in tartaric-sulphuric acid and a post-treatment with a Zr-based conversion coating, obtained at room temperature by immersion in hexafluorozirconic acid (H 2 ZrF 6). To establish the best condition for coating formation on the aluminum oxide layer, different concentration and pH values of the H 2 ZrF 6 solution were studied. Morphological and chemical analyses were performed respectively by SEM and EDS. The corrosion resistance evaluation was carried out by EIS in 0.5 M NaCl. Heterogeneity was observed in the obtained coatings. However, the samples treated with H 2 ZrF 6 had a higher corrosion resistance than unsealed samples. The best concentration and pH range observed for the H 2 ZrF 6 solution were 1 % and 3 to 3.5, respectively. Under these conditions, a greater corrosion resistance was evidenced in comparison to that obtained with boiling water sealing.Keywords
This publication has 27 references indexed in Scilit:
- Effect of acid traces on hydrothermal sealing of anodising layers on 2024 aluminium alloyElectrochimica Acta, 2010
- Degradation of the corrosion resistance of anodic oxide films through immersion in the anodising electrolyteCorrosion Science, 2010
- Preferential anodic oxidation of second‐phase constituents during anodising of AA2024‐T3 and AA7075‐T6 alloysSurface and Interface Analysis, 2010
- Effect of postreatment on the corrosion behaviour of tartaric–sulphuric anodic filmsElectrochimica Acta, 2009
- Modelling the anodizing behaviour of aluminium alloys in sulphuric acid through alloy analoguesCorrosion Science, 2008
- FESEM and EIS Study of Sealed AA2024 T3 Anodized in Sulfuric Acid Electrolytes: Influence of Tartaric AcidJournal of the Electrochemical Society, 2008
- Macroscopic and Local Filming Behavior of AA2024 T3 Aluminum Alloy during Anodizing in Sulfuric Acid ElectrolyteJournal of the Electrochemical Society, 2008
- Anodising of Al 2024-T3 in a modified sulphuric acid/boric acid bath for aeronautical applicationsCorrosion Science, 2003
- Overaging of sealed and unsealed aluminium oxide filmsCorrosion Science, 1997
- Anodic oxide films on aluminumChemical Reviews, 1969