Motion artifacts occurring at the lung/diaphragm interface using 4D CT attenuation correction of 4D PET scans
Open Access
- 1 September 2011
- journal article
- Published by Wiley in Journal of Applied Clinical Medical Physics
- Vol. 12 (4) , 261-274
Abstract
For PET/CT, fast CT acquisition time can lead to errors in attenuation correction, particularly at the lung/diaphragm interface. Gated 4D PET can reduce motion artifacts, though residual artifacts may persist depending on the CT dataset used for attenuation correction. We performed phantom studies to evaluate 4D PET images of targets near a density interface using three different methods for attenuation correction: a single 3D CT (3D CTAC), an averaged 4D CT (CINE CTAC), and a fully phase matched 4D CT (4D CTAC). A phantom was designed with two density regions corresponding to diaphragm and lung. An 8 mL sphere phantom loaded with 18F-FDG was used to represent a lung tumor and background FDG included at an 8:1 ratio. Motion patterns of and were used for dynamic studies. Image data was acquired using a GE Discovery DVCT-PET/CT scanner. Attenuation correction methods were compared based on normalized recovery coefficient (NRC), as well as a novel quantity “fixed activity volume” (FAV) introduced in our report. Image metrics were compared to those determined from a 3D PET scan with no motion present (3D STATIC). Values of FAV and NRC showed significant variation over the motion cycle when corrected by 3D CTAC images. 4D CTAC- and CINE CTAC–corrected PET images reduced these motion artifacts. The amount of artifact reduction is greater when the target is surrounded by lower density material and when motion was based on . 4D CTAC reduced artifacts more than CINE CTAC for most scenarios. For a target surrounded by water equivalent material, there was no advantage to 4D CTAC over CINE CTAC when using the motion pattern. Attenuation correction using both 4D CTAC or CINE CTAC can reduce motion artifacts in regions that include a tissue interface such as the lung/diaphragm border. 4D CTAC is more effective than CINE CTAC at reducing artifacts in some, but not all, scenarios. PACS numbers: 87.57.qp, 87.57.cp
Keywords
This publication has 28 references indexed in Scilit:
- Respiratory-gated CT as a tool for the simulation of breathing artifacts in PET and PET/CTMedical Physics, 2008
- Cine CT for Attenuation Correction in Cardiac PET/CTJournal of Nuclear Medicine, 2007
- 18F-FDG PET definition of gross tumor volume for radiotherapy of non-small cell lung cancer: is a single standardized uptake value threshold approach appropriate?2006
- The contribution of integrated PET/CT to the evolving definition of treatment volumes in radiation treatment planning in lung cancerInternational Journal of Radiation Oncology - Biology - Physics (IJROBP), 2005
- Attenuation correction of PET images with respiration-averaged CT images in PET/CT.2005
- Four‐dimensional (4D) PET/CT imaging of the thoraxMedical Physics, 2004
- A method for incorporating organ motion due to breathing into 3D dose calculations in the liver: Sensitivity to variations in motionMedical Physics, 2003
- PET-CT: accuracy of PET and CT spatial registration of lung lesionsEuropean Journal of Nuclear Medicine and Molecular Imaging, 2003
- Respiratory motion artifacts on PET emission images obtained using CT attenuation correction on PET-CTEuropean Journal of Nuclear Medicine and Molecular Imaging, 2003
- Precise and real-time measurement of 3D tumor motion in lung due to breathing and heartbeat, measured during radiotherapyInternational Journal of Radiation Oncology - Biology - Physics (IJROBP), 2002