Fabrication and Characterization of Ni60A Alloy Coating on Copper Pipe by Plasma Cladding with Induction Heating
Open Access
Abstract
Plasma cladding coupled induction heating was developed and successfully used to fabricate Ni60A coating on the surface of copper pipe. By matching the swing arc with the rotating copper pipe, the cladding efficiency was as high as 32.72 mm2/s. From the head to the tail of the coating, the wear resistance changed from 4.5 to 1.8 times that of pure copper. During the cladding process with constant current, the surface temperature of the cladding zone and the bath depth gradually increased. The corresponding dilution ratio increased, accompanied by the widening of the interface transition zone and the growth of precipitated phases (CrB and Cr23C6). Due to the gradient change of composition, the coating can be regarded as an in situ synthesized gradient coating. The critical point of sudden change of temperature in cladding zone was 850 °C, at which point the wear mechanism changed from abrasive wear to adhesive wear. The proper surface temperature of cladding zone should be controlled within 600–850 °C, which can be achieved by matching the cladding current and induction heating power. Results indicated that plasma cladding coupled induction heating is a potentially effective method to prepare high-quality coating on the surface of a large-complex-curved copper component.Keywords
Funding Information
- State Key Laboratory of Advanced Special Steel, Shanghai Key Laboratory of Advanced Ferrometallurgy and the Science and Technology Commission of Shanghai Municipality (19DZ2270200)
- National Natural Science Foundation of China (51576164)
- National Natural Science Foundation of China and the Joint Research Fund of China Bao-Wu Iron and Steel Group Company Limited (U1860108, U1860203)
This publication has 25 references indexed in Scilit:
- Mechanism Research on Melting Loss of Coppery Tuyere Small Sleeve in Blast FurnaceHigh Temperature Materials and Processes, 2015
- Exploring and estimating in-use steel stocks in civil engineering and buildings from night-time lightsInternational Journal of Remote Sensing, 2012
- Plasma electroplating Ni coating on pure copper sheet—the effects of H2SO4 concentration on the microstructure and mechanical propertiesSurface and Coatings Technology, 2012
- Microstructure and tribological properties of laser-clad Ni–Cr/TiB2 composite coatings on copper with the addition of CaF2Surface and Coatings Technology, 2012
- Outlook of the World Steel Cycle Based on the Stock and Flow DynamicsEnvironmental Science & Technology, 2010
- Laser cladding Ni–Co duplex coating on copper substrateOptics and Lasers in Engineering, 2010
- Characterization on laser clad nickel based alloy coating on pure copperSurface and Coatings Technology, 2008
- Forging the Anthropogenic Iron CycleEnvironmental Science & Technology, 2007
- Pulsed Nd:YAG laser post-treatment Ni-based crack-free coating on copper substrate and its wear propertiesSurface and Coatings Technology, 2007
- Contact and Rubbing of Flat SurfacesJournal of Applied Physics, 1953