Modelling lubrication oil particle emissions from heavy-duty diesel engines
Authors:
- 1 August 2012
- journal article
- Published by SAGE Publications in International Journal of Engine Research
- Vol. 14 (2) , 180-190
Abstract
The impact of lubrication oil on particle exhaust emissions has attracted increasing attention as emissions of fuel-derived particles have been reduced. This paper presents a model for assessing the oil-related exhaust particle emissions of heavy-duty diesel engines. The model contains four sub-models describing the hydrocarbon, ash, carbon and sulphate particles. All sub-models were developed based on the results of a literature review, complemented by controlled engine tests to fill the knowledge gaps and verify assumptions where necessary. Exhaust after-treatment devices, such as diesel particulate filters, are not included in the model at this stage; in engines equipped with such devices, the modelling results could be used to assess the input of oil-related particulate matter into the exhaust after-treatment system or serve as a basis for further development. The modelling results indicate that the contribution of oil to airborne exhaust particles is substantial under low-load and motoring conditions. Reducing oil consumption is an effective way to reduce oil-related particle emissions.Keywords
This publication has 26 references indexed in Scilit:
- Introduction: Focus on Airborne Particulate Matter from the Transport SectorAerosol Science and Technology, 2010
- A Study of Airborne Wear Particles Generated From a Sliding ContactJournal of Tribology, 2009
- PM10 source characterization at urban and highway roadside locationsScience of The Total Environment, 2007
- On-road and laboratory evaluation of combustion aerosols—Part1: Summary of diesel engine resultsJournal of Aerosol Science, 2006
- Speciation and origin of PM10 and PM2.5 in selected European citiesAtmospheric Environment, 2004
- Separate determination of PM10 emission factors of road traffic for tailpipe emissions and emissions from abrasion and resuspension processesInternational Journal of Environment and Pollution, 2004
- Tailpipe, resuspended road dust, and brake-wear emission factors from on-road vehiclesAtmospheric Environment, 2003
- Mechanism of smokeless diesel combustion with oxygenated fuels based on the dependence of the equivalence ration and temperature on soot particle formationInternational Journal of Engine Research, 2002
- Engines and nanoparticlesJournal of Aerosol Science, 1998
- Development and Use of a Spray Combustion Modeling to Predict Diesel Engine Efficiency and Pollutant Emissions : Part 1 Combustion ModelingBulletin of JSME, 1983