Wear Behaviour of Pure Ti with a Nanocrystalline Surface Layer
- 1 July 2011
- journal article
- Published by Trans Tech Publications, Ltd. in Applied Mechanics and Materials
- Vol. 66-68, 1500-1504
Abstract
A nanocrystalline (NC) layer with the thickness of 30 µm was produced on pure titanium surface by surface mechanical attrition treatment (SMAT). Microstructure observation indicated that the grain size increases with depth from the treated surface. The friction coefficient decreases and the wear resistance increases with the SMAT sample as compared to its coarse-grained counterpart. The improvement of the wear properties could be attributed to the higher hardness of SMAT sample.Keywords
This publication has 10 references indexed in Scilit:
- Plasma nitriding behavior of Ti6Al4V orthopedic alloySurface and Coatings Technology, 2008
- Fretting wear behavior of nanocrystalline surface layer of pure copper under oil lubricationTribology Letters, 2007
- Dry-sliding tribological properties of ultrafine-grained Ti prepared by severe plastic deformationActa Materialia, 2005
- Surface modification of titanium, titanium alloys, and related materials for biomedical applicationsMaterials Science and Engineering: R: Reports, 2004
- Nanostructured surface layer on metallic materials induced by surface mechanical attrition treatmentMaterials Science and Engineering: A, 2004
- Effect of surface nanocrystallization on friction and wear properties in low carbon steelMaterials Science and Engineering: A, 2003
- Oxygen boost diffusion for the deep-case hardening of titanium alloysMaterials Science and Engineering: A, 2000
- Nanostructured materials: basic concepts and microstructureActa Materialia, 2000
- Evolution of dislocation structure induced by cyclic deformation in a directionally solidified cobalt base superalloyMaterials Science and Technology, 1999
- Titanium alloys in total joint replacement—a materials science perspectiveBiomaterials, 1998