Adsorption Behaviors of a Twin-Tower Hydrogen Purification System Mounted onto Staggered Stainless Steel Sheets Coated with Composite Membrane
Open Access
Abstract
Many studies have been conducted on hydrogen production, storage, purification, and transportation. The use of fixed-bed adsorption towers for hydrogen purification is common. The operating variables involved that could affect the adsorption behavior, such as the amount of adsorbents used, the flow rate, and the concentration of the adsorbate, should be discussed further. In addition, the pressure drop caused by the operation of the adsorption tower still needs to be considered. Therefore, the staggered stainless steel sheet coatings with SiO2/MCM41/activated carbon composite membrane were mounted in a twin-tower adsorption system to purify the hydrogen. Similar to the pressure swing adsorption (PSA) system, the amounts of SiO2, activated carbon, and molecular sieves used in the adsorption tower were changed into the amounts of tetraethoxysilane (TEOS), activated carbon powder, and MCM41 powder added to the casting solution. The experimental results showed that the performance of this twin-tower hydrogen purification system would not be increased when one of the target adsorbents was excessive. In addition, the outflow of non-hydrogen components was found to be early when a certain adsorbent was not sufficient. Finally, the recommended switching time for this system was set at an adsorption capacity reaching about 75% saturated capacity.Keywords
This publication has 20 references indexed in Scilit:
- A parametric study of process design and cycle configurations for pre-combustion PSA applied to NGCC power plantsChemical Engineering Research and Design, 2020
- Comparison of structured activated carbon and traditional adsorbents for purification of H2Separation and Purification Technology, 2020
- Hydrogen separation from mixed gas (H2, N2) using Pd/Al2O3 membrane under forced unsteady state operationsInternational Journal of Hydrogen Energy, 2020
- Particulate and membrane molecular sieves prepared to adsorb carbon dioxide in packed and staggered adsorberChemical Industry and Chemical Engineering Quarterly, 2018
- Effect of PBI-HFA surface treatments on Pd/PBI-HFA composite gas separation membranesInternational Journal of Hydrogen Energy, 2017
- High performance composite hollow fiber membranes for CO2/H2 and CO2/N2 separationInternational Journal of Hydrogen Energy, 2014
- Effect of dry/wet-phase inversion method on fabricating polyetherimide-derived CMS membrane for H2/N2 separationInternational Journal of Hydrogen Energy, 2010
- Hydrogen mixture separation with PEEK-WC asymmetric membranesSeparation and Purification Technology, 2009
- Hydrogen purification by the multibed pressure swing adsorption processReactive Polymers, Ion Exchangers, Sorbents, 1987
- The optimal control of a periodic adsorber: Part I. ExperimentAIChE Journal, 1972