Development of a Gasoline Particulate Filter for China 6(b) Emission Standards
Authors:
- 4 September 2017
- conference paper
- Published by SAE International in SAE International Journal of Advances and Current Practices in Mobility
- Vol. 1
Abstract
New emissions regulations of light-duty vehicles (China 6) will be implemented in China from July 1, 2020. This standard includes two stages, China 6a and China 6(b), in which the PM limits of 4.5 mg/km and 3.0 mg/km are introduced respectively; the PN limit is set to be 6×1011 #/km for both stages. The WLTC testing cycle will be implemented in China 6 regulation as well. In this study a light-duty vehicle satisfying China 6(b) emission standards was developed by improving the engine raw emissions, optimizing the calibration and adding a coated GPF to the after-treatment system. The impacts of ash content and consumption of engine oil and the fast ash accumulation to vehicle emissions and backpressure were analyzed through dynamometer testing. The vehicle after-treatment system was then designed and developed to meet China 6(b) emission standards. The characteristics of soot accumulated through mimicking routine driving under cold environments were tested. The critical conditions of passive regeneration and the controlling strategies of active regenerations of GPF were also studied.Keywords
This publication has 20 references indexed in Scilit:
- Next Generation of Ceramic Wall Flow Gasoline Particulate Filter with Integrated Three Way CatalystSAE International Journal of Advances and Current Practices in Mobility, 2015
- Strategies to Control Particulate Emissions of Gasoline Direct Injection Engines2012
- Application of Catalyzed Gasoline Particulate Filters to GDI VehiclesSAE International Journal of Engines, 2012
- Effects of Gasoline Direct Injection Engine Operating Parameters on Particle Number EmissionsEnergy & Fuels, 2012
- An analysis of direct-injection spark-ignition (DISI) soot morphologyAtmospheric Environment, 2012
- New Particulate Filter Concept to Reduce Particle Number EmissionsSAE International Journal of Advances and Current Practices in Mobility, 2011
- The Influence of DISI Engine Operating Parameters on Particle Number EmissionsSAE International Journal of Advances and Current Practices in Mobility, 2011
- Strategies Towards Meeting Future Particulate Matter Emission Requirements in Homogeneous Gasoline Direct Injection EnginesSAE International Journal of Engines, 2011
- Filtration Behavior of Diesel Particulate Filters (1)SAE International Journal of Advances and Current Practices in Mobility, 2007
- Air-Fuel Mixing in a Homogeneous Charge DI Gasoline EngineSAE International Journal of Advances and Current Practices in Mobility, 2001