Remapping algorithms: application to trimming operations in sheet metal forming
Open Access
- 31 August 2016
- conference paper
- Published by IOP Publishing in Journal of Physics: Conference Series
- Vol. 734 (3) , 032046
Abstract
Most of sheet metal forming processes comprise intermediate trimming operations to remove superfluous material. These operations are required for subsequent forming operations. On the other hand, the springback is strongly influenced by the trimming operations that change the part stiffness and the stress field. From the numerical point of view, this involves the geometrical trimming of the finite element mesh and subsequent remapping of the state variables. This study presents a remapping method based on Dual Kriging interpolation, specifically developed for hexahedral finite elements, which has been implemented in DD3TRIM in-house code. Its performance is compared with the one of the Incremental Volumetric Remapping method, using the split-ring test to highlight their advantages and limitations. The numerical simulation of the forming processes is performed with DD3IMP finite element solver.Keywords
This publication has 8 references indexed in Scilit:
- Experimental and numerical studies on the warm deep drawing of an Al–Mg alloyInternational Journal of Mechanical Sciences, 2015
- Trimming of 3D solid finite element meshes: sheet metal forming tests and applicationsEngineering with Computers, 2013
- Application of the Incremental Volumetric Remapping Method in the Simulation of Multi-Step Deep Drawing ProcessesAIP Conference Proceedings, 2005
- Common‐refinement‐based data transfer between non‐matching meshes in multiphysics simulationsInternational Journal for Numerical Methods in Engineering, 2004
- A remeshing algorithm based on bubble packing method and its application to large deformation problemsFinite Elements in Analysis and Design, 2003
- Material state remapping in computational solid mechanicsInternational Journal for Numerical Methods in Engineering, 2002
- Three-dimensional numerical simulation of the deep-drawing process using solid finite elementsJournal of Materials Processing Technology, 2000
- Transfer operators for evolving meshes in small strain elasto-placticityComputer Methods in Applied Mechanics and Engineering, 1996