Development of a floating liner test rig and lubrication model for the study of the piston compression ring friction force under fully flooded and starved lubrication
Authors:
- Vicente MaciánVMVicente Macián
- Bernardo TormosBTBernardo Tormos
- Vicente BermúdezVBVicente Bermúdez
- Sophia BastidasSBSophia Bastidas
Open Access
- 1 August 2021
- journal article
- research article
- Published by Elsevier in Tribology International
- Vol. 160
Abstract
No abstract availableKeywords
Funding Information
- Universitat Politècnica de València (PAID-01-17)
This publication has 37 references indexed in Scilit:
- Practical challenges in determining piston ring frictionProceedings of the Institution of Mechanical Engineers, Part J: Journal of Engineering Tribology, 2012
- The influence of piston ring geometry and topography on frictionProceedings of the Institution of Mechanical Engineers, Part J: Journal of Engineering Tribology, 2012
- Tri-Axial Force Measurements on the Cylinder of a Motored SI Engine Operated on Lubricants of Differing ViscosityJournal of Engineering for Gas Turbines and Power, 2010
- Piston friction analysis using a direct-injection single-cylinder gasoline engineJSAE Review, 2003
- Review of Power Cylinder Friction for Diesel EnginesJournal of Engineering for Gas Turbines and Power, 2000
- Analysis of lubrication and friction for a complete piston-ring pack with an improved oil availability model: Part 1: Circumferentially uniform filmProceedings of the Institution of Mechanical Engineers, Part J: Journal of Engineering Tribology, 1997
- Implementation of an Algorithm to Model the Starved Lubrication of a Piston Ring in Distorted Bores: Prediction of Oil Flow and Onset of Gas Blow-ByProceedings of the Institution of Mechanical Engineers, Part J: Journal of Engineering Tribology, 1996
- Theoretical Analysis of Piston-Ring Lubrication Part I—Fully Flooded LubricationTribology Transactions, 1992
- The Starved Lubrication of Piston Rings in a Diesel EngineJournal of Mechanical Engineering Science, 1978
- The Contact of Two Nominally Flat Rough SurfacesProceedings of the Institution of Mechanical Engineers, 1970