A study on the analytical modeling for warm hydro-mechanical deep drawing of lightweight materials
Authors:
- Ho ChoiHCHo Choi
- Muammer KoçMKMuammer Koç
- Jun NiJNJun Ni
- 1 September 2007
- journal article
- Published by Elsevier in International Journal of Machine Tools and Manufacture
- Vol. 47 (11) , 1752-1766
Abstract
No abstract availableThis publication has 17 references indexed in Scilit:
- Plastic instability in dual-pressure tube-hydroforming processInternational Journal of Mechanical Sciences, 2005
- A prediction of bursting failure in tube hydroforming process based on plastic instabilityThe International Journal of Advanced Manufacturing Technology, 2005
- Tensile deformation behavior of aluminum alloys at warm forming temperaturesMaterials Science and Engineering: A, 2003
- Analytical study for tube hydroformingJournal of Materials Processing Technology, 2002
- Prediction of forming limits and parameters in the tube hydroforming processInternational Journal of Machine Tools and Manufacture, 2002
- The effects of temperature and forming speed on the forming limit diagram for type 5083 aluminum–magnesium alloy sheetJournal of Materials Processing Technology, 2001
- Deep Drawability of 5083 Al-Mg Alloy Sheet at Elevated Temperature and its PredictionKey Engineering Materials, 2000
- Analysis of draw–redraw processesInternational Journal of Mechanical Sciences, 1998
- Rupture instability in hydroforming deep-drawing processInternational Journal of Mechanical Sciences, 1985
- Cup-drawing from a Flat Blank: Part I. Experimental InvestigationProceedings of the Institution of Mechanical Engineers, 1951