Effect of Sintering Parameters on Microstructural Evolution of Low Sintered Geopolymer Based on Kaolin and Ground-Granulated Blast-Furnace Slag
Authors:
- Noorina Hidayu JamilNJNoorina Hidayu Jamil
- Mohd Mustafa Al Bakri AbdullahMohd Mustafa Al Bakri Abdullah
- Wan Mohd Arif W. IbrahimWIWan Mohd Arif W. Ibrahim
- Razna RahimRRRazna Rahim
- Andrei Victor SanduAndrei Victor Sandu
- Petrica VizureanuPetrica Vizureanu
- João Castro-GomesJoão Castro-Gomes
- José Manuel Gómez-SoberónJosé Manuel Gómez-Soberón
Open Access
Abstract
The effect of different sintering parameters on the mechanical properties of sintered kaolin-GGBS will influence the variation of mechanical properties of sintered kaolin-GGBS geopolymer. Based on previous research, the samples have major cracking and many large pores due to the sintering temperature and holding time during the sintering process. The first objective is to study the effect of different sintering parameters on the mechanical properties of sintered kaolin-GGBS geopolymer and the second objective is to correlate the strength properties of sintered kaolin-GGBS geopolymer with microstructural analysis. In a solid-to-liquid 2:1 ratio, kaolin and GGBS were combined with an alkali activator. The kaolin-GGBS geopolymer was then cured at room temperature for 24 h. The samples were then cured for 14 days at 60 °C, followed by using double-step sintering at temperatures of 500 °C and 900 °C with varying heating rates and holding durations. The compressive strength and shrinkage of the kaolin-GGBS geopolymer were evaluated, and the morphology was examined using a scanning electron microscope. In comparison to other samples, the sintered kaolin-GGBS geopolymer with a heating rate of 2 °C and a holding duration of 2 h had the optimum compressive strength value: 22.32 MPa. This is due to the contribution of MgO from GGBS that refines the pore and increases the strength. The 13.72% shrinkage with a densified microstructure was also obtained at this parameter due to effective particle rearrangement during sintering.Keywords
Funding Information
- Ministry of Higher Education, Malaysia (FRGS/1/2020/TK0/UNIMAP/01/2)
- TUIASI from the University Scientific Research Fund (FCSU)
This publication has 19 references indexed in Scilit:
- Functional glass-ceramic foams from ‘inorganic gel casting’ and sintering of glass/slag mixturesJournal of Cleaner Production, 2018
- A review of two-step sintering for ceramicsCeramics International, 2016
- Characterization and Microstructure of Kaolin-Based Ceramic Using GeopolymerizationKey Engineering Materials, 2016
- Advances in 27Al MAS NMR Studies of Geopolymers2016
- Geopolymer from kaolin in China: An overviewApplied Clay Science, 2016
- Efficiency of ground granulated blast-furnace slag replacement in ceramic waste aggregate mortarCement and Concrete Composites, 2014
- Kaolin-based geopolymers with various NaOH concentrationsInternational Journal of Minerals, Metallurgy and Materials, 2013
- Mechanical Properties of Kaolin during HeatingKey Engineering Materials, 2012
- Characterization and thermal behavior of kaolinJournal of Thermal Analysis and Calorimetry, 2011
- Effect of Heating Rate on Phase and Microstructural Evolution During Pressureless Sintering of a Nanostructured Transition AluminaInternational Journal of Applied Ceramic Technology, 2009