Two-Phase Flow Splitting at an Impacting Tee

Authors:

Abstract
Summary This paper describes laboratory air/water and field steam flow tests conducted to develop a reliable method for predicting the qualities of split streams and to find tee insert devices that increase the range of vapor-phase split ratios for which split qualities are equal. The results show that an empirical correlation based on air/water tests can be applied to field steam-distribution systems for predicting phase-splitting problems. The splitting problems are corrected by using the tee insert devices tested. Test data show that of the insert devices that were evaluated, the downstream nozzles produced equal-quality splits over the widest range of vapor-phase split ratios. Introduction Steamflooding involves the injection of heat into a reservoir in the form of two-phase steam. For the process to be effective, steam of sufficient quality must be injected at sufficient rates into different parts of a reservoir. Furthermore, to maximize steam-displacement efficiency and volumetric sweep of the reservoir, it is necessary to distribute injected heat and mass uniformly over a steamflood area. It is also important to maintain an optimal quality of steam entering the reservoir because steam vapor and liquid have different displacement mechanisms.1 A predetermined quality of steam must be delivered to a given wellhead at a predetermined rate. Critical flow chokes are used to control steam rates to each injection well.2 Impacting (dead-end) tees3 are used at pipe branches in an attempt to achieve even steam-quality distribution to each well (Fig. 1). Unfortunately, wellhead quality and rate measurements collected in various steamflood projects indicate that uneven quality splits often occur whenever the rate splits deviate from 50:50 at a pipe tee.4 Individual wells receive uneven and unpredictable portions of the steam heat and mass. Uneven heat and mass distributions result in poor displacement efficiency and volumetric sweep of the reservoir while unknown steam-quality distribution leads to poor reservoir heat management and inaccurate material-balance analysis. Therefore, it is important to obtain a better understanding of two-phase flow splitting at impacting tees. In addition, it is helpful to develop a means to predict accurately and, if possible, to equalize the qualities of split streams at the pipe tee. This paper describes laboratory air/water and field steam flow-splitting tests that were conducted to develop a reliable method for predicting the qualities of split streams and to find several mechanical devices that can be inserted into an impacting tee to improve quality distribution in steam lines.

This publication has 9 references indexed in Scilit: