Effects of Cooling Rate during Quenching and Tempering Conditions on Microstructures and Mechanical Properties of Carbon Steel Flange
Open Access
- 21 September 2020
- Vol. 13 (18) , 4186
Abstract
This study investigated the mechanical properties of steel in flanges, with the goal of obtaining high strength and high toughness. Quenching was applied alone or in combination with tempering at one of nine combinations of three temperatures TTEM and durations tTEM. Cooling rates at various flange locations during quenching were first estimated using finite element method simulation, and the three locations were selected for mechanical testing in terms of cooling rate. Microstructures of specimens were observed at each condition. Tensile test and hardness test were performed at room temperature, and a Charpy impact test was performed at −46 °C. All specimens had a multiphase microstructure composed of matrix and secondary phases, which decomposed under the various tempering conditions. Decrease in cooling rate (CR) during quenching caused reduction in hardness and strength but did not affect low-temperature toughness significantly. After tempering, hardness and strength were reduced and low-temperature toughness was increased. Microstructures and mechanical properties under the various tempering conditions and CRs during quenching were discussed. This work was based on the properties directly obtained from flanges under industrial processes and is thus expected to be useful for practical applications.Keywords
Funding Information
- Small and Medium Business Administration (S2641289)
- Korea Evaluation Institute of Industrial Technology (10080728)
This publication has 60 references indexed in Scilit:
- Relationship between yield point phenomena and the nanoindentation pop-in behavior of steelJournal of Materials Research, 2011
- Spheroidizing kinetics and optimization of heat treatment parameters in CK60 steel using taguchi robust designJournal of Iron and Steel Research International, 2010
- Nanoindentation and microstructure analysis of resistance spot welded dual phase steelMaterials Letters, 2010
- Influence of different initial microstructure on the process of spheroidization in cold forgingMaterials & Design (1980-2015), 2008
- Characterisation and Quantification of Complex Bainitic Microstructures in High and Ultra-High Strength Linepipe SteelsMaterials Science Forum, 2005
- Ductile-Brittle Transition Temperature of Ultrafine Ferrite/Cementite Microstructure in a Low Carbon Steel Controlled by Effective Grain SizeISIJ International, 2004
- Ferritic Microstructures in Continuously Cooled Low- and Ultralow-carbon Steels.ISIJ International, 1995
- MICROSTRUCTURE OF GRANULAR BAINITELe Journal de Physique Colloques, 1988
- A crystallographic study of pearlite growth in steels.Transactions of the Iron and Steel Institute of Japan, 1983
- Dislocation Theory of Yielding and Strain Ageing of IronProceedings of the Physical Society. Section A, 1949