Characteristics of Novel Dental Composites Containing 2,2-Bis[4-(2-methoxy-3-methacryloyloxy propoxy) phenyl] propane as a Base Resin
Authors:
- 22 November 2005
- journal article
- research article
- Published by American Chemical Society (ACS) in Biomacromolecules
- Vol. 7 (1) , 154-160
Abstract
Many dental restorative dental composites still utilize 2,2-bis[4-(2-hydroxy-3-methacryloyloxy propoxy) phenyl] propane (Bis-GMA) as base resin. The high viscosity of Bis-GMA necessitates dilution with dimethacrylate ethers of low viscosity such as triethylene glycol dimethacrylate (TEGDMA). However, increased amounts of the TEGDMA have adverse effects on properties such as water uptake and curing shrinkage. The viscosity of the base resin should be as low as possible to enable the preparation of dental composites with a minimum content of diluent. To overcome the disadvantage of Bis-GMA, i.e., its high viscosity caused by hydrogen bonding between hydroxyl groups, 2,2-bis[4-(2-methoxy-3-methacryloyloxy propoxy) phenyl propane (Bis-M-GMA) was prepared by substituting methoxy groups for hydroxyl groups in Bis-GMA. The viscosity of Bis-GMA was dramatically decreased from 574 (Pa.s) to 3.7 (Pa.s) by substitution of methoxy group. Consequently, the amount of TEGDMA included in the resin matrix could be minimized. Dental composites were prepared from Bis-M-GMA (or Bis-GMA) mixtures with TEGDMA filled with 75 wt % filler. Comparing the curing shrinkage of dental composite containing Bis-M-GMA with that prepared from Bis-GMA, the reduction in curing shrinkage was about 47%. Dental composites prepared from new resin matrixes also exhibited low water uptake and better properties in mechanical strength.Keywords
This publication has 14 references indexed in Scilit:
- Interpretation of bond failure through conversion and residual solvent measurements and Weibull analyses of flexural and microtensile bond strengths of bonding agentsDental Materials, 2005
- Influence of light-curing procedures and photo-initiator/co-initiator composition on the degree of conversion of light-curing resinsJournal of Materials Science: Materials in Medicine, 2005
- Study of water sorption, solubility and modulus of elasticity of light-cured dimethacrylate-based dental resinsBiomaterials, 2003
- Characterization of association phenomena in aqueous systems of chitosan of different hydrophobicity1Part of this paper was presented at the conference on `Associating Polymer', Fontevraud, France, November 1997.1Advances in Colloid and Interface Science, 1999
- Synthesis of BISGMA derivatives, properties of their polymers and compositesJournal of Materials Science: Materials in Medicine, 1997
- Reattaching Fractured Tooth Segments: An Esthetic AlternativeThe Journal of the American Dental Association, 1992
- Using Composite Resin as a Posterior Restorative MaterialThe Journal of the American Dental Association, 1991
- Hydrogen iodide/zinc iodide: a new initiating system for living cationic polymerization of vinyl ethers at room temperatureMacromolecules, 1987
- Composites for use in posterior teeth: Mechanical properties tested under dry and wet conditionsJournal of Biomedical Materials Research, 1986
- Fluoride Release from a Silicophosphate Cement with Added FluorideJournal of Dental Research, 1982