Influence of Mixed-Lubrication and Rough Elastic-Plastic Contact on the Performance of Small Fluid Film Bearings
Authors:
- 22 September 2008
- journal article
- research article
- Published by Taylor & Francis in Tribology Transactions
- Vol. 51 (6) , 699-717
Abstract
A previously developed deterministic elastohydrodynamic (EHD) numerical model for small fluid film bearings functioning in the mixed lubrication regime is extended in this work by considering the rough contact. Several simplifying hypotheses are made: the shaft is considered rigid and smooth, turning at low speeds (isothermal regime), and the pad is assumed to have an elastic-perfectly-plastic behavior. The Reynolds equation is solved on a very fine mesh and the elasto-plastic pad deformation caused by the hydrodynamic pressure is taken into account. A deterministic active set-based method is used for determining the contact pressure, the contact extent, and the corresponding deformation. The results are presented for a partial journal bearing configuration, with a linear shaft velocity of 0.47 m/s under specific pressures varying up to 50 MPa. Two pad materials are considered, and the lubricant is either isoviscous or piezoviscous oil. The simulation results, presented as a function of the bearing specific pressure, include eccentricity, the film thickness, the friction torques, the contact extent, etc. Stribeck curves showing the evolution of the friction coefficient in the hydrodynamic and mixed lubrication regimes are also discussed.Keywords
This publication has 26 references indexed in Scilit:
- Finite element method for mixed elastohydrodynamic lubrication of journal‐bearing systemsInternational Journal for Numerical Methods in Engineering, 2004
- Relevance of the thermoelastohydrodynamic model in the analysis of a plain journal bearing subjected to severe operating conditionsProceedings of the Institution of Mechanical Engineers, Part J: Journal of Engineering Tribology, 2004
- A Mixed Elastohydrodynamic Lubrication Model With Asperity ContactJournal of Tribology, 1999
- Fast Methods for Solving Rough Contact Problems: A Comparative StudyJournal of Tribology, 1999
- A Mixed-TEHD Model for Journal-Bearing Conformal Contacts—Part I: Model Formulation and Approximation of Heat Transfer Considering Asperity ContactJournal of Tribology, 1998
- An FFT-Based Method for Rough Surface ContactJournal of Tribology, 1997
- The Effects of Surface Texture on EHL Point ContactsJournal of Tribology, 1996
- Behavior of Elastic-Plastic Rough Surface Contacts as Affected by Surface Topography, Load, and Material HardnessTribology Transactions, 1996
- The Influence of Longitudinal and Transverse Roughness on the Elastohydrodynamic Lubrication of Circular ContactsJournal of Tribology, 1988
- An Average Flow Model for Determining Effects of Three-Dimensional Roughness on Partial Hydrodynamic LubricationJournal of Lubrication Technology, 1978