Development and Assessment of Pressure-Based and Model-Based Techniques for the MFB50 Control of a Euro VI 3.0L Diesel Engine
Authors:
- 28 March 2017
- journal article
- research article
- Published by SAE International in SAE International Journal of Engines
- Vol. 10 (4) , 1538-1555
Abstract
Pressure-based and model-based techniques for the control of MFB50 (crank angle at which 50% of the fuel mass fraction has burned) have been developed, assessed and tested by means of rapid prototyping (RP) on a FPT F1C 3.0L Euro VI diesel engine.The pressure-based technique requires the utilization of a pressure transducer for each cylinder. The transducers are used to perform the instantaneous measurement of the in-cylinder pressure, in order to derive its corresponding burned mass fraction and the actual value of MFB50. It essentially consists of a closed-loop approach, which is based on a cycle-by-cycle and cylinder-to-cylinder correction of the start of injection of the main pulse (SOImain), in order to achieve the desired target of MFB50 for each cylinder.The model-based technique, instead, requires the adoption of a heat release predictive model to simulate MFB50; this model is based on an improved version of the accumulated fuel mass approach, which requires the injection rate as input. This control technique is essentially based on the inversion of the heat release model, in order to identify the optimal value of SOImain that allows the desired MFB50 target to be achieved cycle-by-cycle. The approach is therefore of the open-loop type.Both control techniques were developed and assessed by means of Model-in-the-Loop (MiL) and Hardware-in-the-Loop (HiL) techniques, and then tested on the engine using a rapid prototyping device. The experimental tests were performed on a highly dynamic test bench at the Politecnico di Torino.These techniques have shown a good potential for MFB50 control, compared to the standard methodology implemented in the Engine Control Unit (ECU).Keywords
This publication has 42 references indexed in Scilit:
- Cylinder Pressure-Based Closed Loop Combustion Control: A Valid Support to Fulfill Current and Future Requirements of Diesel Powertrain SystemsSAE International Journal of Advances and Current Practices in Mobility, 2015
- A Feed-Forward Approach for the Real-Time Estimation and Control of MFB50 and SOI In Diesel EnginesSAE International Journal of Engines, 2014
- MFB50 on-board estimation methodology for combustion controlControl Engineering Practice, 2013
- Assessment of Closed-Loop Combustion Control Capability for Biodiesel Blending Detection and Combustion Impact Mitigation for an Euro5 Automotive Diesel EngineSAE International Journal of Advances and Current Practices in Mobility, 2011
- Combustion control using a Model-based MFB50 estimation methodologyIFAC Proceedings Volumes, 2010
- Instantaneous Engine Speed Measurement and Processing for MFB50 EvaluationSAE International Journal of Engines, 2009
- Combustion System Optimization of a Low Compression-Ratio PCCI Diesel Engine for Light-Duty ApplicationSAE International Journal of Engines, 2009
- Optimization and Testing of a Through the Road Parallel, Hybrid-Electric, Crossover Sports Utility VehicleSAE International Journal of Advances and Current Practices in Mobility, 2009
- Fast heat release characterization of a diesel engineInternational Journal of Thermal Sciences, 2008
- Development and testing of diesel engine CFD modelsProgress in Energy and Combustion Science, 1995