Yielding Behaviour of Martensite in Steel
Authors:
- 1 January 2015
- journal article
- Published by Iron and Steel Institute of Japan in ISIJ International
- Vol. 55 (5) , 1114-1122
Abstract
Although martensite is recognised as a very strong phase in carbon steels, its initial yielding commences at low stresses and the tensile stress-strain curve shows a smooth, rounded form. Evidence is presented from x-ray diffraction to show that this behaviour is due to the presence of intra-granular stresses that are residues after the shear transformation from austenite to martensite. These internal stresses are reduced in magnitude by plastic deformation and also by tempering. Reduction of internal stress due to plasticity is shown by a decrease in XRD line broadening after deformation. A simple model is presented in which the stress-strain behaviour is controlled by relaxation of the internal stresses almost up to the point of the ultimate tensile strength. It demonstrates that only a very small fraction of the material remaining in a purely elastic state provides a large stabilising effect resisting necking. A corollary of this is that the uniform elongation of martensitic steel actually increases with increase in the strength level. Effects of heat treatment are also reproduced in the model, including the increase in conventional yield stress (Rp0.2) that occurs after low temperature temperingKeywords
This publication has 12 references indexed in Scilit:
- Three dimensional elasto-plastic phase field simulation of martensitic transformation in polycrystalMaterials Science and Engineering: A, 2012
- Toward a New Interpretation of the Mechanical Behaviour of As-quenched Low Alloyed Martensitic SteelsISIJ International, 2012
- Microstructures and hardness of as-quenched martensites (0.1–0.5%C)Acta Materialia, 2011
- Effect of Dislocation Distribution on the Yielding of Highly Dislocated IronMaterials Science Forum, 2007
- Evolution of intergranular stresses during in situ straining of IF steel with different grain sizesMaterials Science and Engineering: A, 2006
- Simple Flow Rules for Modeling the Behaviour of Inhomogeneous Viscoplastic MaterialsAdvanced Engineering Materials, 2005
- Deformation, fracture, and mechanical properties of low-temperature-tempered martensite in SAE 43xx steelsMetallurgical and Materials Transactions A, 1997
- Heat Treated Martensitic Steels: Microstructural Systems for Advanced Manufacture.ISIJ International, 1995
- Elastic limits and microplastic response in ultrahigh strength carbon steelsMetallurgical Transactions A, 1989
- X-ray studies of deformed metalsProgress in Metal Physics, 1959