Friction Measurement of Al-17%Si Monolithic Cylinder with using Newly Developed Floating Liner Device
Authors:
- 11 November 2014
- journal article
- Published by SAE International in SAE International Journal of Engines
- Vol. 08 (1) , 135-142
Abstract
The improvement of fuel consumption is the most important issue for engine manufactures from the viewpoint of energy and environment conservation. A piston-cylinder system plays an important role for the reduction of an engine friction. For the improvement of the frictional behavior of the piston-cylinder system, it is beneficial to observe and analyze the frictional waveforms during an engine operation.To meet the above-mentioned demand, frictional waveforms were measured with using the renewed floating liner device. In the newly developed floating liner device, an actual cylinder block itself was used as a test specimen.The measured single cylinder was an aluminum monolithic type made of hypereutectic Al-17%Si alloy using a high pressure die casting process. The combined piston was a light weight forged piston and a DLC coated piston ring was used. For the measurement, 110cc air cooled single cylinder engine was used.The observed waveforms were considered to be reasonable and proper from the theoretical point of view. A friction mean effective pressure (FMEP) value was also calculated on each measurement conditions. The FMEP was increased with increasing a load of an engine operation. It was considered that the increase of the FMEP was attributable to the increase of a side force of the piston. Furthermore it was proved that the FMEP was decreased through its running-in process. The FMEP after running-in was 30% lower than that before running-in. This phenomenon was due to the change in the roughness of contact surfaces. And also the tribofilm formed on the contact surface would contribute to the reduction of the FMEP.Keywords
This publication has 6 references indexed in Scilit:
- Microstructural evolution of a eutectic Al–Si engine subjected to severe running conditionsMaterials Science and Engineering: A, 2009
- Origins of the wear resistance of AlSi cylinder bore surfaces studies by surface analytical toolsTribology International, 2007
- Hypereutectic Al-20%Si Alloy Engine Block Using High-Pressure Die-CastingSAE International Journal of Advances and Current Practices in Mobility, 2004
- Effect of Surface Morphology on Wear Characteristics of Hypereutectic Al-Si AlloyJournal of the Japan Institute of Metals and Materials, 2004
- A Study of Friction Force Reduction on Piston SkirtTRANSACTIONS OF THE JAPAN SOCIETY OF MECHANICAL ENGINEERS Series B, 1997
- Measurement of Piston Frictional Force in Actual Operating Diesel EngineSAE International Journal of Advances and Current Practices in Mobility, 1979