Austenitizing Temperature and Cooling Rate Effects on the Martensitic Transformation in a Microalloyed-Steel
Open Access
- 1 January 2020
- journal article
- research article
- Published by FapUNIFESP (SciELO) in Materials Research
- Vol. 23 (1)
Abstract
The effects of the austenitizing temperature and the cooling rate upon the kinetic of athermal martensitic transformation in a microalloyed steel were evaluated. Considering the studied steel, the knowledge about these effects on the martensitic transformation has a great relevance for naval manufacturers and steel researchers. In this study, computational simulation was performed aiming to evaluate the phase's stability. Specimens were submitted to quenching simulations in a dilatometer, considering four different austenitizing temperatures and four cooling rates. The results shown that the austenite chemical composition was not significantly affected by the austenitizing temperatures. Both the austenitic grain size and the cooling rate affected the martensitic transformation kinetics. The larger the austenitic grain size, the higher the Ms. The austenitic grain growth promoted a decrease in the required chemical energy to compensate the free energy increase associated with the lattice strain and the creation of new interfaces, leading to a lower austenite undercooling. An extrinsic effect of the cooling rate on the Ms was observed. For lower cooling rates, the carbide precipitation modified que austenite chemical composition, changing its stability and increasing Ms. A predictability equation, correlating the M S with the austenite grain size and the steel cooling rate, was proposed.Keywords
This publication has 17 references indexed in Scilit:
- Martensite transformation in the modified high Cr ferritic heat-resistant steel during continuous coolingJournal of Materials Research, 2012
- Austenite grain size and the martensite-start temperatureScripta Materialia, 2009
- Phase transformation in AISI 410 stainless steelMaterials Science and Engineering: A, 2002
- A new empirical formula for the calculation of MS temperatures in pure iron and super-low carbon alloy steelsJournal of Materials Processing Technology, 2001
- Effects of Carbon Concentration and Cooling Rate on Continuous Cooling Transformations Predicted by Artificial Neural Network.ISIJ International, 1999
- Continuous cooling transformation kinetics versus isothermal transformation kinetics of steels: a phenomenological rationalization of experimental observationsMaterials Science and Engineering: R: Reports, 1995
- Continuous Cooling Transformations in Martensitic Stainless Steels.ISIJ International, 1994
- Optimization of the properties obtained by quenching in martensitic stainless steels X30-40Cr13 and X40-60CrMoV14Journal of Materials Science, 1993
- Kinetics of Martensitic transformation in partially bainitic 300M steelMaterials Science and Engineering: A, 1990
- The effect of titanium and reheating temperature on the microstructure and strength of plain-carbon, vanadium- and niobium-microalloyed steelsJournal of Materials Science, 1990