Investigation of surface topology in ball nose end milling process of Inconel 718
Authors:
- M.S. KasimMKM.S. Kasim
- M.S.A. HafizMHM.S.A. Hafiz
- J.A. GhaniJGJ.A. Ghani
- C.H.C. HaronCHC.H.C. Haron
- R. IzamshahRIR. Izamshah
- S.A. SundiSSS.A. Sundi
- S.B. MohamedSMS.B. Mohamed
- I.S. OthmanIOI.S. Othman
Abstract
No abstract availableKeywords
Funding Information
- Universiti Teknikal Malaysia Melaka
- Ministry of Higher Education (FRGS/1/2018/TK03/UTEM/02/14)
This publication has 45 references indexed in Scilit:
- Machining induced surface integrity in titanium and nickel alloys: A reviewInternational Journal of Machine Tools and Manufacture, 2011
- Aging effects on the microstructure and creep behavior of Inconel 718 superalloyMaterials Science and Engineering: A, 2009
- The influence of tool flank wear on residual stresses induced by milling aluminum alloyJournal of Materials Processing Technology, 2009
- The influence of cutter orientation and workpiece angle on machinability when high-speed milling Inconel 718 under finishing conditionsInternational Journal of Machine Tools and Manufacture, 2007
- Surface roughness optimization in an end-milling operation using the Taguchi design methodJournal of Materials Processing Technology, 2007
- Effect of minimum quantity lubrication (MQL) on tool wear and surface roughness in turning AISI-4340 steelJournal of Materials Processing Technology, 2006
- Surface finish visualisation in high speed, ball nose milling applicationsInternational Journal of Machine Tools and Manufacture, 2005
- Tool life when high speed ball nose end milling Inconel 718™Journal of Materials Processing Technology, 2001
- Integrated tool path and feed rate optimization for the finishing machining of 3D plane surfacesInternational Journal of Machine Tools and Manufacture, 2000
- Machinability of nickel-base super alloys: a general reviewJournal of Materials Processing Technology, 1998