Electrochemical Measurements on Concrete Bridges for Evaluation of Reinforcement Corrosion Rates
Authors:
- J. FlisJFJ. Flis
- H.W. PickeringHPH.W. Pickering
- A. SehgalASA. Sehgal
- 1 July 1993
- journal article
- Published by Association for Materials Protection and Performance (AMPP) in Corrosion
- Vol. 49 (7) , 601-613
Abstract
This study was undertaken to obtain data for development of a methodology and standard for instruments to evaluate the corrosion rate of steel in concrete structures. Measurements of the polarization resistance of reinforcing steel were made with three devices, two of which operated on the principle of linear polarization with or without signal confinement. The third was based on superimposed current pulses of high and low frequency with signal confinement. Bridges were chosen as representative of three environmental conditions: marine environments, regions with mild winters and low use of deicing agents, and regions with cold winters and characterized by extensive use of deicing agents. Measurement procedures were described, and the data obtained were presented on plots of corrosion current (ic) vs corrosion potential (Ec). Values for ic were low and almost independent of Ec when Ec was more noble than about −0.25 V (Cu/CuSO4), Currents increased as Ec shifted in the negative direction. Values of ic were inversely proportional to concrete resistance. The ic results were discussed in terms of the resistance and moisture content of the concrete. The guard electrode confined signal distribution, with confinement dependent upon the resistivity of the concrete.Keywords
This publication has 24 references indexed in Scilit:
- Relationship between conductivity of concrete and corrosion of reinforcing barsBritish Corrosion Journal, 1989
- Three‐Dimensional Modeling of the Potential and Current Distributions in an Electrolytic CellJournal of the Electrochemical Society, 1987
- Corrosion and electrical impedance in concreteCement and Concrete Research, 1985
- Corrosion Inhibition in Neutral, Aerated MediaJournal of the Electrochemical Society, 1985
- Errors in the electrochemical evaluation of very small corrosion rates—I. polarization resistance method applied to corrosion of steel in concreteCorrosion Science, 1985
- Comments on electrochemical measurements of the rate of corrosion of steel in concreteCement and Concrete Research, 1984
- Aspects of the electrochemistry of steel in concreteNature, 1982
- Quantitative measurements of corrosion rate of reinforcing steels embedded in concrete using polarization resistance measurementsMaterials and Corrosion, 1978
- Theoretical Analysis of the Current Density Distribution in Electrolytic CellsJournal of the Electrochemical Society, 1951
- The influence of change of size in electrochemical systemsDiscussions of the Faraday Society, 1947