Experimental Investigation of Sorghum Stalk and Sugarcane Bagasse Hybrid Composite for Particleboard
Open Access
- 7 April 2022
- journal article
- research article
- Published by Hindawi Limited in Advances in Materials Science and Engineering
- Vol. 2022, 1-17
Abstract
This study evaluated the physical-mechanical properties of three-layer particleboard made from sorghum stalk and sugarcane bagasse hybrid reinforced bonded with urea-formaldehyde resin. The production of particleboards using the sorghum and bagasse particles has been established at the ratio of (25:50:75) sorghum stalk and sugarcane bagasse with urea-formaldehyde as a matrix at different concentrations (50kg/m3, 60kg/m3, and 70kg/m3) and pressing pressure (18MPa, 20MPa, and 22MPa) through hand mixing from 3 to 5 minutes and then hot press within a temperature range of 160°C to 180°C for 4 minutes. The particleboards were produced with their proportions through the Taguchi design of the experiment (L9) approach. The experimental results were analyzed using Taguchi design and ANOVA with a general linear model. The experimental results showed that internal bonding, flexural strength, modulus of elasticity, and moisture content were significantly improved with high resin content and pressing pressure from 18MPa to 22MPa. The thickness swelling value also dropped where the resin concentration varies from 50kg/m3 to 70kg/m3 and shows better board stability. In contrast, the water absorption increased as resin content was increased. Results from ANOVA provide that SS3B1P3UFR3 (3:1 ratio of Sorghum with bagasse, 22MPa of pressing load, and 70kg/m3 urea-formaldehyde concentration) is the most optimal combination of variables for the better performance of particleboard.Keywords
This publication has 32 references indexed in Scilit:
- Sugarcane bagasse—The future composite material: A literature reviewResources, Conservation and Recycling, 2013
- The influence of moisture content of raw material on the physical and mechanical properties, surface roughness, wettability, and formaldehyde emission of particleboard compositeComposites Part B: Engineering, 2012
- Eco-friendly aspects associated with friction welding of tube-to-tube plate using an external tool processInternational Journal of Sustainable Engineering, 2012
- Pressure Impact on Common Reed Particleboards Manufacturing ProcedureSystems Engineering Procedia, 2011
- Effect of Addition of Boric Acid and Borax on Fire-Retardant and Mechanical Properties of Urea Formaldehyde Saw Dust CompositesInternational Journal of Carbohydrate Chemistry, 2011
- Suitability of Friction Welding of Tube to Tube Plate Using an External Tool Process for Different Tube Diameters-A StudyExperimental Techniques, 2011
- Effect of Tube Preparations on Joint Strength in Friction Welding of Tube-to-Tube Plate Using an External Tool ProcessExperimental Techniques, 2011
- Effect of curing time on physical and mechanical properties of phenolic-treated bamboo stripsIndustrial Crops and Products, 2009
- Design of Experiments: Useful Orthogonal Arrays for Number of Experiments from 4 to 16Entropy, 2007
- Chemical and physical properties of sugarcane bagasse irradiated with .gamma. raysJournal of Agricultural and Food Chemistry, 1983