Enhancement of Film Cooling Performance Using a Shaped Film Cooling Hole with Compound Angle Injection.
Authors:
- 1 January 2001
- journal article
- Published by Japan Society of Mechanical Engineers in JSME International Journal Series B
- Vol. 44 (1) , 99-110
Abstract
No abstract availableThis publication has 17 references indexed in Scilit:
- Effects of Orientation Angles on Film Cooling Over a Flat Plate: Boundary Layer Temperature Distributions and Adiabatic Film Cooling Effectiveness1999
- Film Cooling Effectiveness and Heat/Mass Transfer Coefficient Measurement Around a Conical-Shaped Hole With a Compound Angle Injection1999
- Experimental mass (heat) transfer in and near a circular hole in a flat plateInternational Journal of Heat and Mass Transfer, 1997
- Heat (Mass) Transfer and Film Cooling Effectiveness With Injection Through Discrete Holes: Part I—Within Holes and on the Back SurfaceJournal of Turbomachinery, 1995
- The Discharge Coefficient of Flared Film Cooling Holes1995
- A review of mass transfer measurements using naphthalene sublimationExperimental Thermal and Fluid Science, 1995
- Behavior of the Laterally Injected Jet in Film Cooling: Measurements of Surface Temperature and Velocity/Temperature Field Within the JetJournal of Turbomachinery, 1994
- The vapour pressure of naphthaleneThe Journal of Chemical Thermodynamics, 1975
- Effects of hole geometry and density on three-dimensional film coolingInternational Journal of Heat and Mass Transfer, 1974
- Film Cooling With Injection Through Holes: Adiabatic Wall Temperatures Downstream of a Circular HoleJournal of Engineering for Power, 1968