Characterization of two maritime pine tannins as wood adhesives
- 24 April 2013
- journal article
- research article
- Published by Taylor & Francis in Journal of Adhesion Science and Technology
- Vol. 27 (22) , 2462-2479
Abstract
Maritime pine tannins from the two suppliers BIOLANDES and DRT were used in combination with paraformaldehyde (5%), hexamine (6%) and glyoxal (9%) as hardener in the preparation of adhesives for wood-based panels. Both tannins showed similar structures according to the matrix-assisted laser desorption/ionization-time of flight analysis. A high reactivity has been checked by gel time measurements and the viscosity increase. Already the BIOLANDES and the DRT tannin alone registered an internal bond (IB) of 0.4 MPa without any hardener. The BIOLANDES tannin with paraformaldehyde could fulfil the European standard EN 312. In general, DRT tannin obtained the best mechanical results. However, the pH and the moisture content play a fundamental role for the final IB. Thus, DRT tannin with glyoxal as hardener at high pH and moisture content gave an IB of 0.51 MPa. The mechanical resistance differences between BIOLANDES and DRT tannin were confirmed by the 13C NMR spectra. DRT tannin presents a lower polymerization de than BIOLANDES, and more reactive sites are available.Keywords
This publication has 37 references indexed in Scilit:
- Comparative kinetics of the induced radical autocondensation of polyflavonoid tannins. II. Flavonoid units effectsJournal of Applied Polymer Science, 1997
- Comparative kinetics of the induced radical autocondensation of polyflavonoid tannins. III. Micellar reactions vs. cellulose surface catalysisJournal of Applied Polymer Science, 1996
- Comparative kinetics of induced radical autocondensation of polyflavonoid tannins. I. Modified and nonmodified tanninsJournal of Applied Polymer Science, 1996
- An ESR study of the silica-induced autocondensation of polyflavonoid tanninsJournal of Applied Polymer Science, 1996
- Matrix-assisted laser desorption/ionization mass spectrometry of synthetic polymers: 2. Analysis of poly(methyl methacrylate)Polymer, 1995
- Induced accelerated autocondensation of polyflavonoid tannins for phenolic polycondensates. III. CP‐MAS 13C‐NMR of different tannins and modelsJournal of Applied Polymer Science, 1995
- Induced accelerated autocondensation of polyflavonoid tannins for phenolic polycondensates. I. 13C‐NMR, 29Si‐NMR, X‐ray, and polarimetry studies and mechanismJournal of Applied Polymer Science, 1994
- A comparative C13 NMR study of polyflavonoid tannin extracts for phenolic polycondensatesJournal of Applied Polymer Science, 1993
- The analysis of water‐soluble polymers by matrix‐assisted laser desorption time‐of‐flight mass spectrometryJournal of Mass Spectrometry, 1992
- Matrix-assisted ultraviolet laser desorption of non-volatile compoundsInternational Journal of Mass Spectrometry and Ion Processes, 1987