Investigation on Mechanism of Ductile Fracture of AA5754 Sheet
Authors:
- 15 July 2006
- journal article
- Published by Trans Tech Publications, Ltd. in Materials Science Forum
- Vol. 519-521, 985-990
Abstract
A number of mechanical tests and metallographic techniques have been used to investigate the mechanism of ductile fracture of AA5754 sheet. The sequence of events in the development of shear localization is clarified using in situ strain mapping on both the sample surface and through thickness direction during tensile tests. It is observed that the failure mode changes from cup-cone type to shearing with increasing Fe content in both continuous cast (CC) and direct-chill cast (DC) AA5754 sheets. However, this transition happens in CC with much lower Fe content than DC. As very little damage is found near the fracture surface, this suggests that damage may be a consequence of the shear process rather than a trigger that determines material ductility. For both CC and DC with same Fe content of 0.21%, fracture strain of CC is much lower than DC. It is postulated that this is due to the differences of particle distribution in these two materials, especially the increased fraction of stringer type structures which exist in CC material.Keywords
This publication has 10 references indexed in Scilit:
- On the sequence of inhomogeneous deformation processes occurring during tensile deformation of strip cast AA5754Acta Materialia, 2006
- Microscopic Strain Mapping Using Scanning Electron Microscopy Topography Image Correlation at Large StrainThe Journal of Strain Analysis for Engineering Design, 2005
- Notch fracture behaviour of 5754 automotive aluminium alloysMaterials Science and Engineering: A, 2002
- Tensile and bending properties of AA5754 aluminum alloysMaterials Science and Engineering: A, 2001
- Serrated Flow and Surface Markings in Aluminum AlloysJournal of Engineering Materials and Technology, 1998
- Heterogeneous initiation and growth of sample-scale shear bands during necking of Al-Mg sheetActa Metallurgica, 1987
- Microstructural aspects of strain localization in AlMg alloysActa Metallurgica, 1986
- Introduction to the viewpoint set on shear bandsScripta Metallurgica, 1984
- Unstable shear failure in a 7075 aluminum alloyActa Metallurgica, 1977
- The effects of hydrostatic pressure on the mechanism of tensile fracture of aluminumMetallurgical Transactions A, 1975