Two-Dimensional Versus Three-Dimensional Finite-Element Method Simulations of Cantilever Magnetoelectric Sensors
Authors:
- 3 May 2013
- journal article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Magnetics
- Vol. 49 (10) , 5287-5293
Abstract
This paper investigates the suitability of two-dimensional (2D) finite-element method (FEM) simulations to model the quasi-static bending-mode response of cantilever magnetoelectric (ME) sensors. We compute the deformation of the cantilever due to an applied magnetic field across the magnetostrictive (MS) layer as well as the generated voltage across the piezoelectric (PE) layer by solving a system of coupled linear elastostatic/elastodynamic and electrostatic/magnetostatic equations. In the 2D FEM formulation a plane-stress boundary condition is employed. Both 2D and 3D FEM results are compared for varying cantilever length and width. For cantilevers with length >> height >> width good agreement is obtained between 2D and 3D results. For cantilevers obeying the condition length >> width >> height, a systematic deviation occurs between 2D and 3D results as the plane-stress condition does not model the situation in the center of the cantilever. For a length:width:height ratio of 25:5:1, a difference in generated voltage of ~12% is obtained for the Terfenol-D-PZT-Si material system. Especially for cantilevers with high aspect ratios, we show that 2D FEM simulations are sufficient to investigate the ME properties.Keywords
This publication has 18 references indexed in Scilit:
- Resonance line shape, strain and electric potential distributions of composite magnetoelectric sensorsAIP Advances, 2013
- Theory of magnetoelectric effect in multilayer nanocomposites on a substrate: Resonant bending-mode responseAIP Advances, 2013
- Equivalence of direct and converse magnetoelectric coefficients in strain-coupled two-phase systemsApplied Physics Letters, 2012
- Finite Element Harmonic Modeling of Magnetoelectric EffectIEEE Transactions on Magnetics, 2011
- Active microcantilevers based on piezoresistive ferromagnetic thin filmsApplied Physics Letters, 2011
- 3D finite element model for magnetoelectric sensorsThe European Physical Journal Applied Physics, 2010
- Enhancement of magnetoelectric coupling in functionally graded ferroelectric and ferromagnetic bilayersPhysical Review B, 2008
- Verified finite element simulation of multiferroic structures: Solutions for conducting and insulating systemsJournal of Applied Physics, 2008
- Finite Element Modeling of Magnetoelectric SensorsIEEE Transactions on Magnetics, 2008
- A new magnetic recording read head technology based on the magneto-electric effectJournal of Physics D: Applied Physics, 2007