EFFECT OF MICROSTRUCTURES ON STRAIN HARDENING EXPONENT PREDICTION OF CAST ALUMINUM ALLOY
Authors:
- Defeng MoDMDefeng Mo
- Xiaoshan LiuXLXiaoshan Liu
- Weihua ZhangWZWeihua Zhang
- 11 February 2010
- journal article
- Published by China Science Publishing & Media Ltd. in ACTA METALLURGICA SINICA
- Vol. 2010 (2) , 184-188
Abstract
Strain hardening exponent(n) of a material is an important parameter reflecting its hardening property whose determination is of great importance.It has a widely application in material scientific research and engineering fields such as fatigue life prediction,stress-concentration factor calculation,etc..The value of strain hardening exponent varies with their microstructures in cast aluminum alloys,but a few theoretical and experimental investigations have been reported to understand the effects of the microstructural parameters on the strain hardening exponent in these alloys till now. In the present study,the influence of secondary dendrite arm spacing(SADS),aspect ratio and volume fraction of particles on internal stress in aluminum alloys were discussed,and a quantitative prediction of strain hardening exponent was established on the basis of Hollomon and internal stress equations.It shows that the strain hardening exponent represents their hardening ability in relatively large plastic deformation(larger than the upper limit for the no plastic relaxation regime).A new microstructural hardening parameter relatively to strain hardening exponent was defined.Besides,a group of A319 cast aluminum alloys with microstructural heterogeneities were tested.The calculated strain hardening exponents are in agreement with the experimental ones in A319 alloy as well as in some commonly used cast aluminum alloys.For the same grade of alloys,the microstructural hardening parameter and strain hardening exponent are quite sensitive to SDAS and particle aspect ratio while the influence of volume fraction of particles is relatively little.As the values of SDAS and aspect ratio of particles increase,the value of the strain hardening exponent decreases.A liner relationship between microstructural hardening parameter and strain hardening exponent was proposed.For A319 and A356/357 alloys,the optimum correction coefficients are 0.17 and 0.11,respectively,and the mean prediction error of n is only about 10%.Keywords
This publication has 20 references indexed in Scilit:
- Determination of strain-hardening exponent using double compression testMaterials Science and Engineering: A, 2009
- Empirical model predicting the value of the strain-hardening exponent of a Ti-IF steel gradeMaterials Science and Engineering: A, 2006
- Plastic deformation behavior of aluminum casting alloys A356/357Metallurgical and Materials Transactions A, 2004
- On precipitate induced hardening in crystal plasticity: theoryInternational Journal of Plasticity, 2004
- Casting defects and the tensile properties of an AlSiMg alloyMaterials Science and Engineering: A, 1996
- The influence of microstructure on the Bauschinger effect in an AlSiMg casting alloyActa Materialia, 1996
- A review of certain aspects of the Bauschinger effect in metalsMaterials Science and Engineering, 1979
- The effect of grain size and strain on the tensile flow stress of aluminium at room temperatureActa Metallurgica, 1977
- Work hardening due to internal stresses in composite materialsActa Metallurgica, 1975
- The deformation of plastically non-homogeneous materialsPhilosophical Magazine, 1970