Effect of abrasive particle hardness on interface response and impact wear behavior of TC17 titanium alloy
Authors:
- 26 September 2018
- journal article
- research article
- Published by IOP Publishing in Materials Research Express
- Vol. 6 (1) , 016521
Abstract
The impact wear behavior, dynamic response, and wear marks of TC17 titanium alloy in soft, hard, and mixed sand environments were studied. As the proportion of soft sand increased, the wear volume decreased significantly. At 75% and 100% of soft sand, "negative" wear occurred, which indicated that the sand adhered to the surface of the specimen. However, no significant difference in peak impact force, impact return speed, and energy absorption was observed in different sand environments. Tests with varied impact velocities were also conducted. For different proportions of sand particles, the wear volume and wear rate varied with increase in impact velocity. An increase in impact velocity resulted in the increase in peak impact force and energy absorption, whereas the contact time and energy absorptivity decreased. However, no significant difference was observed in the peak impact force, impact return speed, and energy absorption under different proportions of sand particles when the impact velocity was a definite value. The main mechanism of TC17 titanium alloy was that hard sand particles were ploughed, extruded, and cut on the specimen surface; the soft sand particles were broken and adhered to the surface of the specimen to form a protective shell.Keywords
Funding Information
- National Natural Science Foundation of China (Nos. 51627806, U1530136)
- Young Scientific Innovation Team of Science and Technology of Sichuan (Nos. 2017TD0017)
- National Key R&D Program of China (Nos. 2016YFB1102601)
This publication has 32 references indexed in Scilit:
- A numerical 3D simulation for prediction of wear caused by solid particle impactWear, 2012
- Particle Transport Analysis of Sand Ingestion in Gas Turbine EnginesJournal of Engineering for Gas Turbines and Power, 2011
- Microstructure, micro-mechanical and tribological properties of the nc-WC/a-C nanocomposite coatings magnetron sputtered on non-hardened and oxygen hardened Ti–6Al–4V alloySurface and Coatings Technology, 2010
- Development, characterization and erosion wear response of plasma sprayed fly ash–aluminum coatingsMaterials & Design (1980-2015), 2010
- A generalized fretting wear theoryTribology International, 2009
- Effect of impingement angle on slurry erosion behaviour and mechanisms of 1017 steel and high-chromium white cast ironWear, 2007
- Effect of erodent properties on erosion wear of ductile type materialsWear, 2006
- Effect of particle velocity and impact angle on the corrosion–erosion of AISI 304 and AISI 420 stainless steelsWear, 2005
- The influence of particle rotation on the solid particle erosion rate of metalsWear, 2004
- Impact wear testing machineWear, 1972