Premixed Low Temperature Combustion of Biodiesel and Blends in a High Speed Compression Ignition Engine
Authors:
- 20 April 2009
- journal article
- Published by SAE International in SAE International Journal of Fuels and Lubricants
- Vol. 02 (1) , 28-40
Abstract
The effects of combining premixed, low temperature combustion (LTC) with biodiesel are relatively unknown to this point. This mode allows simultaneously low soot and NOx emissions by using high rates of EGR and increasing ignition delay. This paper compares engine performance and emissions of neat, soy-based methyl ester biodiesel (B100), B20, B50, pure ultra low sulfur diesel (ULSD) and a Swedish, low aromatic diesel in a multi-cylinder diesel engine operating in a late-injection premixed LTC mode. Using heat release analysis, the progression of LTC combustion was explored by comparing fuel mass fraction burned. B100 had a comparatively long ignition delay compared with Swedish diesel when measured by start of ignition (SOI) to 10% fuel mass fraction burned (CA10). Differences were not as apparent when measured by SOI to start of combustion (SOC) even though their cetane numbers are comparable. Overall, cetane number was a better indicator of combustion phasing as measured by start of injection to 50% mass fraction burned (CA50) than ignition delay when comparing biodiesel with petroleum diesel in premixed LTC. To normalize for combustion phasing, injection timing was adjusted to achieve the same CA50 point for a baseline condition with each fuel. NOX emissions were the same among fuels for a given CA50 whether combustion phasing was adjusted by changing injection timing or injection pressure. Hydrocarbon (HC) emissions for B100 were lower than for ULSD and the same as for Swedish diesel. The filter smoke number (FSN) decreased as the concentration of biodiesel was increased although the particle size distribution increased indicating higher levels of soluble hydrocarbon species were present.Keywords
This publication has 24 references indexed in Scilit:
- Biofuels (alcohols and biodiesel) applications as fuels for internal combustion enginesProgress in Energy and Combustion Science, 2007
- Investigation of Fuel Effects on Dilute, Mixing-Controlled Combustion in an Optical Direct-Injection Diesel EngineEnergy & Fuels, 2007
- Premixed ignition behavior of alternative diesel fuel-relevant compounds in a motored engine experimentCombustion and Flame, 2007
- Diesel soot mass calculation in real-time with a differential mobility spectrometerJournal of Aerosol Science, 2007
- Investigation of the impact of biodiesel fuelling on NOx emissions using an optical direct injection diesel engineInternational Journal of Engine Research, 2006
- Characteristics of SME Biodiesel-Fueled Diesel Particle Emissions and the Kinetics of OxidationEnvironmental Science & Technology, 2006
- Effects on Particle Size Distribution from the Diesel Engine Operating on RME-Biodiesel with EGREnergy & Fuels, 2006
- An experimental study on the effects of oxygenated fuel blends and multiple injection strategies on DI diesel engine emissionsFuel, 1999
- Advanced Approaches for Heat Transfer CalculationsSAE International Journal of Advances and Current Practices in Mobility, 1979
- Development of a Fuel-Based Mass Emission Measurement ProcedureSAE International Journal of Advances and Current Practices in Mobility, 1971