Effects of environmental factors on key kinetic parameters relevant to pitting corrosion
Authors:
Open Access
- 18 March 2015
- journal article
- Published by Springer Nature in Journal of Solid State Electrochemistry
- Vol. 19 (12) , 3449-3461
Abstract
Experiments using stainless steel artificial pit (lead-in-pencil) electrodes in ferric chloride and lithium chloride solutions were performed in order to determine the effects of key environmental factors such as chloride concentration and pH of the bulk solution on the central parameters utilized to characterize the pitting phenomenon—the repassivation potentialErpand the pit stability product under a salt film (i · x)saltfilm. For all the stainless steel alloys studied, a relative independence of theErpto the pit depth was observed once sufficient anodic charge had been passed. The pit stability product under a salt film was seen to be largely insensitive to the pH of the bulk solution.Erp, on the other hand, was fairly independent of bulk pH only at the lower chloride concentrations of both lithium chloride and ferric chloride solutions. The two parameters were affected differently by variation in the chloride concentration of the bulk solutions. Increasing the chloride concentration resulted in a decrease in the value of (i · x)saltfilmfor all alloys in both solutions. In ferric chloride, the value ofErpincreased with increasing chloride concentration for Custom 465 and the austenitic steels, whereas it decreased across the same range for 17–4 pH. These trends were explained qualitatively using solution conductivity and alloying composition arguments. Finally, the results obtained from this study allowed for a rationalization of the phenomenology, enabling a method of measurement of the diffusion coefficient and the concentration at saturation of the “stainless steel cation” within the pit, both of which agreed well with values obtained from the existing literature.Keywords
This publication has 55 references indexed in Scilit:
- Localized Corrosion Susceptibility of Alloy 22 in Chloride Solutions: Part 1—Mill-Annealed ConditionCorrosion, 2005
- Chloride Corrosion Threshold of Reinforcing Steel in Alkaline Solutions—Effect of Specimen SizeCorrosion, 2004
- Crevice Corrosion Stabilization and Repassivation Behavior of Alloy 625 and Alloy 22Corrosion, 2001
- An Electrochemical Approach to Predicting Long-Term Localized Corrosion of Corrosion-Resistant High-Level Waste Container MaterialsCorrosion, 2000
- Surface Roughness and Metastable Pitting of Amorphous Nickel AlloyCorrosion, 1998
- Effect of Applied Potential on Changes in Solution Chemistry Inside Crevices on Type 304L Stainless Steel and Alloy 825Corrosion, 1994
- Crevice Corrosion of Alloy 625 in Chlorinated ASTM Artificial Ocean WaterCorrosion, 1994
- Applicability of Repassivation Potential for Long-Term Prediction of Localized Corrosion of Alloy 825 and Type 316L Stainless SteelCorrosion, 1993
- Relationship Between Conventional Pitting and Protection Potentials and a New, Unique Pitting PotentialCorrosion, 1992
- Metastable Pitting of Stainless SteelCorrosion, 1987