The assessment of wind conditions by means of hot wire sensors and a modifed Wheatstone bridge architecture
Authors:
- V. StornelliVSV. Stornelli
- G. FerriGFG. Ferri
- A. LeoniALA. Leoni
- L. PantoliLPL. Pantoli
- 1 August 2017
- journal article
- Published by Elsevier in Sensors and Actuators A: Physical
- Vol. 262, 130-139
Abstract
No abstract availableThis publication has 16 references indexed in Scilit:
- Coupled Computational Fluid Dynamics and Heat Transfer Modeling of the Effects of Wind Speed and Direction on Temperature Increase of an Ice-Covered FRP Live-Line ToolIEEE Transactions on Power Delivery, 2015
- Fabrication and characterization of a directional anemometer based on a single chip MEMS flow sensorMicroelectronic Engineering, 2011
- LOW VOLTAGE LOW POWER FULLY DIFFERENTIAL BUFFERJournal of Circuits, Systems and Computers, 2009
- Two-dimensional ultrasonic anemometer using the directivity angle of an ultrasonic sensorMicroelectronics Journal, 2008
- Integrated Rail-to-Rail Low-Voltage Low-Power Enhanced DC-Gain Fully Differential Operational Transconductance AmplifierETRI Journal, 2007
- X-probe flow sensor using self-powered active fiber Bragg gratingsSensors and Actuators A: Physical, 2006
- A silicon micromachined flow sensor using thermopiles for heat transfer measurementsIEEE Transactions on Instrumentation and Measurement, 2003
- Hot-wire anemometer with temperature compensation using only one sensorIEEE Transactions on Instrumentation and Measurement, 2001
- Circuits for voltage tuning the parameters of Chua's circuit: Experimental application for musical signal generationJournal of the Franklin Institute, 1994
- Dynamic response of thermoresistive sensorsIEEE Transactions on Instrumentation and Measurement, 1992