Removal of laser-melted material with an assist gas
Authors:
- 15 June 1998
- journal article
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 83 (12) , 7467-7473
Abstract
Molten material is removed in many laser applications such as laser grooving and laser cutting. An assist gas is usually used to remove the molten material from the laser material interaction zone. The effect of assist gas pressure on the material removal rate is investigated in this article for laser cutting and grooving applications. The model for melt depth is based on the overall energy balance, and the cut depth is obtained by considering the effect of the assist gas. The model for kerf width is based on the modified Rosenthal solution taking into account the melting effect. The cut depths reach a constant value beyond a critical pressure if the kerf width is of the order of nozzle width and through cuts are assumed. Most of the molten material is removed by the assist gas at pressures below this critical pressure. The model predicts on the basis of the Prandtl or Meyer relation that the cutting speed decreases when the assist gas pressure exceeds a critical value if the kerf dimensions are smaller than the nozzle dimensions.Keywords
This publication has 9 references indexed in Scilit:
- Scaling laws for thick-section cutting with a chemical oxygen–iodine laserJournal of Laser Applications, 1997
- Theoretical and experimental studies of thick-section cutting with a chemical oxygen–iodine laser (COIL)Journal of Laser Applications, 1996
- CW laser machining of hard ceramics—I. Effects of three-dimensional conduction, variable properties and various laser parametersInternational Journal of Heat and Mass Transfer, 1993
- Combustion-Assisted Laser Cutting of a Difficult-to-Machine SuperalloyJournal of Laser Applications, 1992
- Multiple Reflection Effects on Evaporative Cutting With a Moving CW LaserJournal of Heat Transfer, 1991
- Cutting of Al-Alloys Using High-Pressure Coaxial NozzleJournal of Laser Applications, 1991
- A method to determine the parameters of laser cuttingOptics & Laser Technology, 1989
- A method to determine the parameters of laser iron and steel cuttingOptics & Laser Technology, 1987
- Evaporative Cutting of a Semi-infinite Body With a Moving CW LaserJournal of Heat Transfer, 1986