Growth kinetics and pesting resistance of MoSi2 and germanium‐doped MoSi2 diffusion coatings grown by the pack cementation method
Authors:
- 1 April 1995
- journal article
- Published by Wiley in Materials and Corrosion
- Vol. 46 (4) , 207-217
Abstract
The rapid, destructive low‐temperature oxidation (pesting) of MoSi2 is an important limitation to its practical use. The growth of molybdenum silicide diffusion coatings by a halide‐activated pack cementation method results in an adherent superficial, salt by‐product, whose composition depends on the halide activator used to grow the coating. As a consequence of the residual salt deposit, coatings grown by a NaF‐activated pack did not pest after 2500 hours of isothermal oxidation or after cyclic oxidation for 600 1 hour cycles in air at 500°C. An additional minor improvement in the pesting resistance was observed for the germanium‐doped MoSi2 Coatings.The growth kinetics for a three‐layer Ge‐doped Mo(Si, Ge)2/Mo5(Si, Ge)3/Mo3(Si, Ge) coating are compared with rates calculated for the diffusion‐controlled growth of an undoped three‐layer silicide and for three‐layer germanide coatings. The activation energy for the solid‐state diffusional growth of MoSi2 is the same as that for Mo(Si, Ge)2, but the growth rates for Mo(Si, Ge)2 are faster. The activation energies for the solid state diffusional growth of the inner Mo5(Si, Ge)3 and Mo3(Si, Ge) layers are similar to Mo5Ge3 and Mo3Ge, but the rates are slower. The chemical demixing of Mo(Si, Ge)2 under a chemical potential gradient creates a maximum in the Ge concentration at the Mo(Si, Ge)2/Mo5(Si, Ge)3 interface, which produces unusual growth kinetics for the Mo5(Si, Ge)3 and Mo3(Si, Ge) layers.Keywords
This publication has 26 references indexed in Scilit:
- Pesting of the high-temperature intermetallic MoSi2JOM, 1993
- MoSi2-Based High-Temperature Structural SilicidesMRS Bulletin, 1993
- Low-temperature oxidation of molybdenum disilicideMetallurgical Transactions A, 1992
- A comparative overview of molybdenum disilicide compositesMaterials Science and Engineering: A, 1992
- Deposition and Cyclic Oxidation Behavior of a Protective ( Mo , W ) ( Si , Ge ) 2 Coating on Nb‐Base AlloysJournal of the Electrochemical Society, 1992
- Codepositing elements by halide-activated pack cementationJOM, 1991
- Multilayer diffusional growth in silver-zinc alloysMetallurgical Transactions A, 1981
- Enhanced oxidation of molybdenum disilicide under tensile stress: Relation to pest mechanismsMetallurgical Transactions, 1970
- High-Temperature OxidationJournal of the Electrochemical Society, 1965
- High‐Temperature Behavior of MoSi 2 and Mo 5 Si 3Journal of the American Ceramic Society, 1964