The mechanics of spin coating of polymer films
Author:
- 1 October 1988
- journal article
- conference paper
- Published by AIP Publishing in The Physics of Fluids
- Vol. 31 (10) , 2786-2795
Abstract
The process of spin coating is described, with particular attention to applications in microelectronics. The physical mechanisms involved in the process are discussed and those mechanisms that affect the final state are identified, viz., centrifugal and viscous forces, solute diffusion, and solvent evaporation: A model is proposed that incorporates only the latter mechanisms, with viscosity and diffusivity depending on solute concentration. The evaporation of solvent during spinning causes the solution viscosity to increase and the flow is reduced. The thickness of the final solid film is related to the thickness of a diffusion boundary layer near the free surface. The model predicts the final dry film thickness in terms of the primary process variables, spin speed, and initial polymer concentration. A similarity boundary‐layer analysis leads to a simple approximate result for the final film thickness that is consistent with limited experimental data, hf ∼KC0(ν0D0)1/4/Ω1/2, where K is a number of order unity and the other quantities are, respectively, the initial polymer concentration, the kinematic viscosity, the solute diffusivity, and the spin speed. The dependence on diffusivity has not previously been described theoretically. The total spin time is shown to be proportional to Ω−1, in agreement with experiment. The rate of solvent evaporation is shown to be proportional to Ω, which contradicts previous assumptions.Keywords
This publication has 24 references indexed in Scilit:
- The effects of inertia and interfacial shear on film flow on a rotating diskThe Physics of Fluids, 1988
- Hydrodynamic arrest of a flat body moving towards a parallel surface at arbitrary Reynolds numberJournal of Fluid Mechanics, 1988
- The rheology and spin coating of polyimide solutionsPolymer Engineering & Science, 1983
- Investigation of the solvent‐evaporation effect on spin coating of thin filmsPolymer Engineering & Science, 1983
- Film thickness of a Bingham liquid on a rotating diskIndustrial & Engineering Chemistry Fundamentals, 1982
- An investigation of spin coating of electron resistsPolymer Engineering & Science, 1979
- On the Uniformity of Thin Films: A New Technique Applied to PolyimidesJournal of the Electrochemical Society, 1979
- Spreading of a non-Newtonian liquid over the surface of centrifugal atomizersChemical and Petroleum Engineering, 1976
- Diffusiosmessungen an polymeren in lösung mittels tracer‐technikJournal of Polymer Science Part C: Polymer Symposia, 1967
- Untersuchungen über das Reibungsverhalten von Polymethacrylsäuremethylestern in verschiedenen LösungsmittelnDie Makromolekulare Chemie, 1963