Effect of Bondline Thickness on the Static Strength of Structural Adhesives Under Nearly-Homogeneous Shear Stresses
- 1 July 2011
- journal article
- research article
- Published by Taylor & Francis in The Journal of Adhesion
- Vol. 87 (7-8) , 780-803
Abstract
An usual experimental observation retrieved in the technical literature is that the strength of an adhesive joint decreases by increasing the adhesive layer thickness. This well-known behaviour is still not completely understood. All works found in the literature consider a complex stress state in the adhesive with mode mixing, stress concentrations on the midplane, and stress singularities at the interface occurring at the same time. This paper aims at estimating the effect of the adhesive thickness on its intrinsic static shear strength and evaluate whether this strength can explain the behaviour of a real bonded joint. A nearly uniform shear stress distribution is obtained through an ad-hoc tubular butt joint subject to pure torsion. A standard single lap joint is considered as a benchmark, due to its complex and singular stress field into the adhesive. The experimental campaign is focused on two brittle adhesives: a modified methacrylate and high-strength epoxy. Four levels and three levels of the adhesive thickness were considered in the tubular butt joint and in the single lap joint, respectively, all in the range between 0.05 and 0.4 mm. The effect of the adhesive thickness on the static strength of the adhesive is investigated by considering the type of failure and by comparing the structural stresses in the tubular butt joint with the ones on the midplane of the adhesive layer in the single lap joint. Moreover, the stress intensity factor in the single lap joint is calculated.Keywords
This publication has 19 references indexed in Scilit:
- Stress intensity factor in bonded joints: Influence of the geometryInternational Journal of Adhesion and Adhesives, 2010
- Experimental and numerical analysis of single-lap joints for the automotive industryInternational Journal of Adhesion and Adhesives, 2009
- Design of adhesive joints based on peak elastic stressesInternational Journal of Adhesion and Adhesives, 2008
- Impact rupture of structural adhesive joints under different stress combinationsInternational Journal of Impact Engineering, 2008
- Effect of Adhesive Thickness on Joint Strength: A Molecular Dynamics PerspectiveThe Journal of Adhesion, 2008
- Effect of Adhesive Type and Thickness on the Lap Shear StrengthThe Journal of Adhesion, 2006
- Analysis and evaluation of bondline thickness effects on failure load in adhesively bonded structuresJournal of Adhesion Science and Technology, 2001
- Global yielding as a failure criterion for bonded jointsInternational Journal of Adhesion and Adhesives, 1989
- Mechanical Characterization of Adhesive Layerin-situand as Bulk MaterialThe Journal of Adhesion, 1981
- Stress analysis of adhesive-bonded lap jointsJournal of Strain Analysis, 1974