A Simple and Precise Estimation of Water Sliding Angle by Monitoring Image Brightness: A Case Study of the Fluid Repellency of Commercial Face Masks
Open Access
- 5 April 2022
- journal article
- research article
- Published by American Chemical Society (ACS) in ACS Omega
- Vol. 7 (15) , 13178-13188
Abstract
Fluid repellency of a hydrophobic surface has been typically demonstrated in terms of water sliding angle. A drop shape analysis method with a written computer algorithm monitoring the image brightness was proposed to precisely estimate the sliding angle. A hydrophobic surface coated with silanized silicon dioxide or polytetrafluoroethylene was selected as a known sample for the method validation. Average pixel brightness in an 8-bit grayscale unit rapidly increased after a water drop rolled off the surface, thus removing its black pixels. The resulting sliding angle was then determined as the tilt angle of the sample stage related to the sliding time at the brightness leap. The optimized angular speed of the rotor at 0.1 degrees per frame was chosen to avoid an overestimation of the sliding angle due to the deceleration. The proposed method yielded accurate sliding angles with an error of less than 0.2 degrees. It was then applied to study the fluid resistance of commercial face masks including disposable surgical masks and reusable fabric masks. It was found that the outermost layer of the single-use surgical masks can moderately repel a water drop with a sliding angle of 49.4 degrees. Meanwhile, the pre-coated fabric masks retained high protection efficiency at a sliding angle of less than 45 degrees after about 20 wash cycles. In addition, a raw muslin fabric coated with a commercial water-repellent spray could be a promising and affordable alternative to the surgical mask during the pandemic with high water repellency even after a few washes. The results suggested that, besides the hydrophobicity indicated by the typical contact angle, the precise sliding angle estimated by the proposed alternative method could additionally provide crucial information that might lead to a detailed discussion of the fluid repellency of rough materials.Keywords
Funding Information
- Thailand Science Research and Innovation (1499754/2021, 2472757/2022)
This publication has 49 references indexed in Scilit:
- Antifouling Coatings: Recent Developments in the Design of Surfaces That Prevent Fouling by Proteins, Bacteria, and Marine OrganismsAdvanced Materials, 2010
- A Novel Self-Cleaning Coating with Silicon Carbide NanowiresThe Journal of Physical Chemistry B, 2009
- Understanding of sliding and contact angle results in tilted plate experimentsColloids and Surfaces A: Physicochemical and Engineering Aspects, 2008
- Contact Angle Hysteresis ExplainedLangmuir, 2006
- Superhydrophobic PTFE Surfaces by ExtensionMacromolecular Rapid Communications, 2004
- Effects of Surface Structure on the Hydrophobicity and Sliding Behavior of Water DropletsLangmuir, 2002
- Effects of the Surface Roughness on Sliding Angles of Water Droplets on Superhydrophobic SurfacesLangmuir, 2000
- Contact angle measurement and contact angle interpretationAdvances in Colloid and Interface Science, 1999
- Interactions between heterogeneous surfaces of polymers and waterJournal of Applied Polymer Science, 1994
- Contact angle, wetting, and adhesion: a critical reviewJournal of Adhesion Science and Technology, 1992