BOILING HEAT TRANSFER MECHANISMS IN A HORIZONTAL TUBE BUNDLE
Authors:
- 1 July 1993
- journal article
- research article
- Published by Taylor & Francis in Experimental Heat Transfer
- Vol. 6 (3) , 259-271
Abstract
The effect of thermal environment on boiling heat transfer performance in a section of a horizontal tube bundle was investigated using R-113 as the working fluid. The in-line tube bundle has five columns and 27 rows with a pitch-to-diameter ratio of 1.3. Heal transfer coefficients obtained from the instrumented tube in the tube bundle with only one tube heated while the other tubes remained unhealed and with all the lubes in the bundle heated are reported for a range of heat flux, pressure, mass flow rate, and quality. The results showed that heat transfer coefficient of a tube in a heated bundle is slightly higher than that in an unhealed bundle, with the variation of heat transfer coefficient decreasing as heat flux, mass flow rate, or pressure increased. It was also found that higher quality would tend to improve the heat transfer. However, the effect of quality disappeared as heat flux, mass flow rate, and pressure increased. Based on the experimental data, the mechanism of the heat transfer augment due to thermal environment was analyzed. It was proposed that fluid agitation and thin liquid film formation are two main factors for a heated bundle to have better transfer performance than an unhealed bundle,Keywords
This publication has 4 references indexed in Scilit:
- Forced convective boiling in horizontal tube bundlesInternational Journal of Heat and Mass Transfer, 1986
- Boiling Heat Transfer From a Horizontal Tube in an Upward Flowing Two-Phase CrossflowJournal of Heat Transfer, 1984
- A study of boiling outside a tube bundle using high speed photographyInternational Journal of Heat and Mass Transfer, 1982
- A CORRELATION FOR BOILING HEAT TRANSFER TO SATURATED FLUIDS IN CONVECTIVE FLOW1962