Effects of various oxidizers on chemical mechanical polishing performance of nickel for microelectromechanical system applications
- 22 June 2006
- journal article
- Published by American Vacuum Society in Journal of Vacuum Science & Technology A
- Vol. 24 (4) , 1297-1301
Abstract
Nickel and nickel-based alloys are known candidates to realize movable structures for microelectromechanical system (MEMS) application. Chemical mechanical polishing (CMP) has found extensive application in the fabrication of MEMS. In this study, the CMP of nickel was performed using the commercial slurry with the various ratios of different oxidizers and alumina particle as an abrasive. Moreover, the potentiodynamic polarization behaviors were discussed to evaluate the effects of nickel-CMP performance and electrochemical characteristics between nickel and the various oxidizers. As an experimental result, the removal rate of nickel reached a maximum at 1.0vol% of H2O2 concentration. An addition of 5.0wt% alumina (Al2O3) abrasive could improve the removal rate of nickel; however, many scratches were observed. For the case of Fe(NO3)3 addition as an oxidizer, both the removal rate and the surface topography were insufficient for MEMS applications. The potentiodynamic polarization results indicated that the surface chemistry and electrochemical characteristics of nickel play an important role in controlling the polishing behavior of nickel.Keywords
This publication has 18 references indexed in Scilit:
- Semi-abrasive free slurry with acid colloidal silica for copper chemical mechanical planarizationJournal of Materials Science: Materials in Electronics, 2005
- Effects of Silica Slurry Temperature on Chemical Mechanical Polishing for Tetraethyl Orthosilicate FilmJapanese Journal of Applied Physics, 2005
- Removal characteristics of hillock on SnO2 thin film by chemical mechanical polishing processJournal of Vacuum Science & Technology A, 2005
- Chemical mechanical planarization characteristics of WO3 thin film for gas sensingJournal of Vacuum Science & Technology A, 2005
- CMP of hard disk substrate using a colloidal SiO2 slurry: preliminary experimental investigationWear, 2004
- Chemical mechanical polishing of nickel for applications in MEMS devicesMicroelectronic Engineering, 2004
- A chemical mechanical polishing model incorporating both the chemical and mechanical effectsThin Solid Films, 2004
- Effect of Particle Size of Chemical Mechanical Polishing Slurries for Enhanced Polishing with Minimal DefectsJournal of the Electrochemical Society, 2000
- Future of microelectromechanical systems (MEMS)Sensors and Actuators A: Physical, 1996
- High-aspect-ratio photolithography for MEMS applicationsJournal of Microelectromechanical Systems, 1995