CH4 emission estimates from an active landfill site inferred from a combined approach of CFD modelling and in situ FTIR measurements
Open Access
- 25 October 2017
- journal article
- Published by Copernicus GmbH in Atmospheric Measurement Techniques
- Vol. 10 (10) , 3931-3946
Abstract
Globally, the waste sector contributes to nearly a fifth of anthropogenic methane emitted to the atmosphere and is the second largest source of methane in the UK. In recent years great improvements to reduce those emissions have been achieved by the installation of methane recovery systems at landfill sites, and subsequently methane emissions reported in national emission inventories have been reduced. Nevertheless, methane emissions of landfills remain uncertain and quantification of emission fluxes is essential to verify reported emission inventories and to monitor changes in emissions. Here we present a new approach for methane emission quantification from a complex source such as a landfill site by applying a computational fluid dynamics (CFD) model to calibrated in situ measurements of methane as part of a field campaign at a landfill site near Ipswich, UK, in August 2014. The methane distribution for different meteorological scenarios is calculated with the CFD model and compared to methane mole fractions measured by an in situ Fourier-transform infrared (FTIR) spectrometer downwind of the prevailing wind direction. Assuming emissions only from the active site, a mean daytime flux of 0.83 mg m−2 s−1, corresponding to a spatially integrated emission of 53.3 kg h−1, was estimated. The addition of a secondary source area adjacent to the active site, where some methane hotspots were observed, improved the agreement between the simulated and measured methane distribution. As a result, the flux from the active site was reduced slightly to 0.71 mg m−2 s−1 (45.6 kg h−1), and at the same time an additional flux of 0.32 mg m−2 s−1 (30.4 kg h−1) was found from the secondary source area. This highlights the capability of our method to distinguish between different emission areas of the landfill site, which can provide more detailed information about emission source apportionment compared to other methods deriving bulk emissions.Keywords
All Related Versions
Funding Information
- Natural Environment Research Council (NE/K002465/1, NE/K002570/1)
This publication has 48 references indexed in Scilit:
- Uncontrolled methane emissions from a MSW landfill surface: Influence of landfill features and side slopesWaste Management, 2013
- Pitfalls with the use of enhancement ratios or normalized excess mixing ratios measured in plumes to characterize pollution sources and agingAtmospheric Measurement Techniques, 2013
- Variability of methane emissions from an old landfill over different time‐scalesEuropean Journal of Soil Science, 2013
- CH4/CO2 ratios indicate highly efficient methane oxidation by a pumice landfill cover-soilWaste Management, 2013
- MUST experiment simulations using CFD and integral modelsInternational Journal of Environment and Pollution, 2011
- Microbial methane oxidation processes and technologies for mitigation of landfill gas emissionsWaste Management & Research: The Journal for a Sustainable Circular Economy, 2009
- CFD and Gaussian atmospheric dispersion models: A comparison for leak from carbon dioxide transportation and storage facilitiesAtmospheric Environment, 2008
- On the use of the k– model in commercial CFD software to model the neutral atmospheric boundary layerJournal of Wind Engineering and Industrial Aerodynamics, 2007
- Landfill methane emissions measured by enclosure and atmospheric tracer methodsJournal of Geophysical Research: Atmospheres, 1996
- Progress in the development of a Reynolds-stress turbulence closureJournal of Fluid Mechanics, 1975